Panasonic WV-NP472E operating instructions Installations, Mounting and Adjusting the Lens

INSTALLATIONS

Mounting and Adjusting the Lens

•Replacement of Auto Iris Lens Connector

If necessary, replace the existing lens connector with the type YFE419J100 supplied.

1.Cut the existing lens connector from the iris control cable at its end.

2. Process the cable end as shown in the figure.

8 mm (5/8")

2 mm (1/16")

3.Solder each wire to the pin. Pin #1: Red/Power

Pin #2: Not used

Pin #3: White/Video

Pin #4: Black/GND, Shield

Pin 3	Rib
Pin 1	Pin 4
	Pin 2

4. Attach the cover to the connector.

Cover

Lens

•Mounting the Lens Notes:

•Using the lens having improper protrusion will damage the camera. The protrusion of the lens into the camera body should be within the length indi- cated in the figure.

C-mount: Less than 13 mm (1/2”)

CS-mount: Less than 8 mm (5/16”)

•Secure both the lens and camera with the support- er (not supplied) if a lens heavier than 450 g (0.99 lbs) is mounted.

1.Attach the C-mount adapter (not supplied) when using a C-mount lens.

The camera at the factory shipment can accept only a CS-mount lens.

2.Jump to step 3 if the lens has focus adjusting mechanism. Loosen the flange-back screw, and rotate the adjusting ring down until it stops on the side of the camera.

Lens Mount

C-mount Adapter (Locally procured)

WV -NP472

Flange-back

Adjusting Ring & Screw

3.Mount the lens.

4.Connect the lens cable to the auto iris connector

on the side of the camera.

-7-