Panasonic WV-NP472E Flange-back Adjustment, Mounting from the Bottom, Mounting from the Top

•Flange-back Adjustment

The adjustment is required only when a lens without focus-adjusting mechanism is mounted, or when a lens with adjusting mechanism is mounted and focus that is more accurate is needed.

1.Loosen the flange-back fixing screw on the flange- back adjusting ring.

2.Turn the flange-back adjusting ring to obtain a focused point while watching the monitor screen.

3.Tighten the flange-back fixing screw softly and securely.

Note: The object may be out of focus when using a source of near-infrared light rather than using the visible light.

Mounting the Camera

The mounting adapter can be secured on either the top or bottom (at the factory shipment) of the camera. The mounting hole is a standard photographic pan-head screw size (1/4”-20).

Camera-mounting bracket (Locally procured)

Adapter on the bottom at the factory shipment

•Mounting from the Bottom

1.Secure the camera on the camera-mounting brack- et (locally procured), referring to the manual includ- ed with the bracket.

•Mounting from the Top

1.Remove the mounting adapter from the bottom of the camera.

2.Attach the mounting adapter on top of the camera as shown in the figure.

Fixing Screws

Mounting Adapter

WV -NP472

3.Secure the camera to the camera-mounting brack- et (locally procured), referring to the manual includ- ed with the bracket.

Note: Use the original two screws to attach the mounting adapter on the camera. Using short- er ones may cause the camera to fall down, or longer ones may damage the inside of the camera.

•Pictures Upside-down

You can reverse the picture upside-down in the menu setup when it is necessary.

Note: The right and left of the picture are not reversed.

-8-