Panasonic AW-E860L manual Select SC Fine on the sub menu. Perform fine, Colour phase adjustment

Caution:	4. Select [SC Fine] on the sub menu. Perform fine
• When horizontal phase adjustment is required using RCU	adjustment with the YES/ABC switch and the NO/BAR
(RCB) or hybrid control panel, BAR/CAM switch should be	switch.
set to BAR. Horizontal phase cannot be adjusted if the
switch is in the CAM position. After adjustment set
BAR/CAM switch back to CAM.
• When horizontal phase adjustment is moved, colour phase
is also moved. Adjust colour phase whenever horizontal
phase adjustment is moved.

U Colour phase adjustment

Supply the output signal (split colour bar) from the colour special effect generator to a colour monitor or vectorscope. Adjust the colour phase of the camera.

[ADJUSTMENT with RCU (RCB, Hybrid control panel)]

ENGLISH

Colour bar of camera

Sprit line

Colour bar of special effects generator

[ADJUSTMENT by camera]

1.Press the NO/BAR switch for over 5 seconds for the colour bar mode.

2.Select [G/L Adjustment] on the main menu, then select [SC Coarse] on the sub menu.

3.Make coarse adjustment with the YES/ABC switch and the NO/BAR switch.

Use the subcarrier phase coarse adjustment control and subcarrier phase fine control.

❈It is recommended that a vectorscope be used for maximum accuracy in colour phase adjustment.

Caution:

•When colour phase adjustment is required using RCU (RCB) or hybrid control panel, BAR/CAM switch should be set to BAR. Colour phase cannot be adjusted if the switch is in the CAM position. After adjustment set BAR/CAM switch back to CAM.

•When horizontal phase adjustment is moved, colour phase is also moved. Adjust colour phase whenever horizontal phase adjustment is moved.

-26 (E) -