Adjustment

Minimize the carrier wave using the red & blue gain controls

Waveform for white balance set chart

$ Reset to 3200K or 5600K white balance

When the white balance setting is set to either “3200K” or “5600K” the white balance will be automatically set to the colour temperature 3200K or 5600K, respectively.

$ Black balance adjustment

Close the lens.

If the motor drive lens is controlled from the camera, the lens is automatically closed when the black balance is adjusted.

When the camera is used without a RCU or RCB, R/B pedestal adjustment of painting setting will be automatically reset to ±0 after setting the black balance. (painting setting in only User Mode.)

[ADJUSTMENT by CAMERA]

Press the YES/ABC switch for over 2 seconds and the black balance will be set automatically in 10 seconds.

In user mode, black balance fine adjustment can be performed with the red pedestal/blue pedestal setting after setting the black balance.

[ADJUSTMENT with the RCU (RCB, hybrid control panel)]

Set the AUTO set switch to ABC and the black balance will be automatically set. While the system is being set, the auto warning indicator (LED) blinks and it goes out when the black balance setting is completed. If the lamp remains lit, ABC should be tried again.

YES/ABC switch

AUTO LED

AUTO set switch

- 23 (E) -

Page 24
Image 24
Panasonic AW-E860L manual $ Reset to 3200K or 5600K white balance, $ Black balance adjustment, 23 E, YES/ABC switch