Panasonic AW-E860L manual Other Set Display

Menu item setting

;Other Set Display

jGamma Level Setting [Gamma: 0.35 to 0.55] Gamma correction level can be set.

kKnee Level Setting

[Knee Point: 88% to 98%, Dynamic]

88% to 98%: The level of video signals subject to knee (knee point) can be set.

Dynamic: Knee level is automatically adjusted according to the scene.

lWhite Clip Level Setting [White Clip: 95% to 110%] The peak level of video signals to be white-clipped can be set.

mFlare Correction Level Setting [Flare R/G/B: 0 to 100] Flare correction level can be adjusted.

nBlack Stretch Setting [Black Stretch: ON, OFF]

Black stretch to correct the suppression of black portions at low luminance can be set to ON or OFF.

oClean DNR Setting [Clean DNR: OFF, Low, High] This enables the clean DNR effect to be selected.

pCCD Read Out Mode Setting [Field/Frame: Field, Frame 1, Frame 2] Field: CCD storage will be by field storage.

Frame 1: Vertical resolution increases in frame storage.

Frame 2: Vertical resolution is raised without increasing residual images by frame storage and electronic shutter.

qPC Control Access Speed Setting [Baud Rate: 1200bps, 2400bps, 4800bps, 9600bps]

This setting is to select a communication speed in controlling the camera from the computer.

rComponent Output Setting [Signal Select: RGB, Y/Pr/Pb, Y/C]

This enables RGB, Y/Pr/Pb or Y/C to be selected as the component signals which are to be output from the I/F REMOTE connector.

sAspect Ratio Selection [Aspect Ratio: 16:9, 4:3] Aspect ratio can be selected from 16:9 or 4:3.

tFan Setting [Fan SW: OFF, Auto]

OFF: Select this setting to stop the fan when its operating sound is found to be bothersome in a studio or other such environment.

Auto: The temperature is detected automatically, and the fan starts operating when the temperature exceeds approx. 35°C.

Under normal circumstances, the “Auto” setting is used.

-49 (E) -