4.Set the following parameters.

Note: Ask your system administrator about param- eters if you are unsure.

IP Address: Enter numbers 0 through 255 into four sections split by dots.

Netmask: Enter numbers 0 through 255 into four sections split by dots.

Default Gateway: Enter numbers 0 through 255 into four sections split by dots

Host Name: Enter the host name.

Network Speed: Select a speed.

HTTP Port: Enter different numbers for each when multiple cameras are connected.

DNS (Domain Name System): Set to ON when using DNS. Enter the primary address. If nec- essary, enter the secondary address.

DHCP (Dynamic Host Configuration Protocol): When set to ON, you need not input for the IP address, netmask, and default gateway.

Note: You can forcibly change the IP address of the camera as follows, if you have wrongly set DHCP to ON in the system where no DHCP server exists.

1.Start up DOS prompt.

2.Execute "arp-s<enter here a new IP address><MAC address of the camera>".

3.Execute "ping-t<enter here a new IP address>".

4.Press “Ctrl” key and “C” key to stop execution if correctly responded.

Function Comparison / PC Network vs. Camera site

Carry out only when the system has no DHCP server.

The new IP address should be within the same subnet.

Procedures above will not function when the system is running normally.

5.Click the SET & REBOOT button. The changed parameters will be validated, and the camera and the PC will restart.

Note: Do not omit the step 4 above to validate new parameters.

6.Close the browser software, and the PC.

Access from the Camera/System Device

You can operate and set up the camera from such sys- tem devices as Video Multiplexer, Matrix Switcher, or system controller if connected.

You can operate and set up at the camera site using the side panel buttons on the camera while observing the monitor.

Note: See the manuals included with the system devices for operating the camera from them.

Function

PC Network

Camera Site (*1)

VIEWING IMAGES

 

 

Zoom (with Panasonic’s motorized lens)

NA

A

 

 

 

Focus

NA

A

 

 

 

Iris (with Panasonic’s ALC lens)

A

A

 

 

 

Switching Colour/BW Mode

A

A

 

 

 

AUX Device Control

A

NA

 

 

 

Alarm Log/Alarm Image Display

A

NA

 

 

 

MENU SETUPS

 

 

 

 

 

Camera Setup (Camera)

A

A

 

 

 

Network Setup (Camera)

A

A

 

 

 

Network Setup (HTML)

A

NA

 

 

 

Operating Mode Setup (HTML)

A

NA

 

 

 

Alarm Setup (HTML)

A

NA

 

 

 

FTP Client Setup (HTML)

A

NA

 

 

 

User Authentication (HTML)

A

NA

 

 

 

Host Authentication (HTML)

A

NA

 

 

 

System Setup (HTML)

A

NA

A:Available, NA: Not Available

Note:

*1 A system device e.g. Video Multiplexer, or a system controller operates the setup menus. Side panel buttons on the camera can do it as well.

-12-

Page 12
Image 12
Panasonic WV-NP472E operating instructions Access from the Camera/System Device, Network Speed Select a speed