1.Open the Alarm Setup window.
2.External Alarm
•Select ON or OFF, and click the SET button. ON: Receives alarm inputs via the ALARM IN
terminal.
OFF: Ignores alarm inputs via the ALARM IN terminal.
3.
•Select ON or OFF for
ON: Sends an
OFF: Does not send.
•Enter the
A hostname.domainname can be entered when using the DNS function.
•Enter the sender name. The default setting is NW_camera.
•Select ON or OFF for Attach Image.
ON: Attaches the image data to an
OFF: Does not attach.
•Click the SET & REBOOT button.
•Enter a maximum of 4 destination addresses, and click the SET button.
•Click the DEL (delete) button after selecting an unwanted destination to cancel it.
4.Recording Setup
The image fields are stored before and after the alarm input in the memories of the camera.
•Set the image frame numbers for the pre recording (0 - 10) and post recording (1 - 20).
•Set the recording rate (fps: frame per second).
Rates for Before: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5
Rates for After: 1/10, 1/5, 1/3, 1/2, 1, 2, 3.3, 5, 10
•Click the SET & REBOOT button.
5.Panasonic Protocol Setup
•Select ON or OFF.
ON: Sends alarm notice mails to the cus- tomized destinations.
OFF: Does not send.
•Enter the destination port. The port number is exclusively assigned to this function, and any other usage is not allowed.
•Enter the retry times from 1 to 25.
•Click the SET button.
•Enter a maximum of 8 destination IP address- es, and click the SET button.
•Click the DEL (delete) button after selecting an unwanted destination to cancel it.
6.External Terminal Output Setup
The alarm output is supplied from the terminal on the rear of the camera.
•Select a signal type that the connected device accepts.
Pulse: Holds active status during the specified time width.
Latch: Holds active status until it is reset man- ually.
•Enter pulse width (n x 100
•Click the SET & REBOOT button.
7.Alarm Reset
•Click the ALARM RESET button to cancel the activated alarm.
■FTP Client Setup
Image files can be transferred to the FTP server within the scheduled time zone.
1. Open the FTP Client Setup window.
