U-Line CLRCO2075 manual Water Supply Connection, Locally-Installed Drain Pump

™ CLRCO2075 — Clear Ice Maker/Refrigerator

5.Place a suitable container beneath the pump’s discharge tube. (The bucket must be able to hold a minimum of one gallon.)

6.Plug the ice maker power cord into a properly grounded, polarized electrical outlet.

7.Verify pump operation by pouring one gallon of water into the ice storage bin of the ice maker. The pump should energize and pump the water into the container.

CAUTION

In the event of a power outage, restricted drain or pump failure, the failure to use the U-Line P60 drain pump or a pump with the above listed specifications, could result in substantial water leakage and pooling with severe and costly water damage and related consequential damages and harm.

8.At this time, verify that all tube and clamp connections are tight and leak free.

9.Unplug unit power cord from electrical outlet.

10.Reinstall back panel.

To connect to drain:

1.Attach the 5/8-inch ID drain connection on the back of the unit to a 5/8-inch OD rigid tube, using a worm clamp.

2.Attach the other end of the rigid tube to your 5/8-inch ID drain line with a worm clamp.

3.Insulate the drain line, if necessary to prevent condensation. Go on to Water Supply Connection.

Locally-Installed Drain Pump

If a gravity drain connection is not possible, and you have not purchased the CLRCO2075 with factory-installed pump, we strongly recommend the use of the U-Line P60 drain pump. The U-Line P60 drain pump is available through your Dealer, or direct from U-Line with complete installation instructions. If a pump other than the U-Line P60 drain pump is to be used, it must meet the following

Water Supply Connection

When connecting the water supply, follow these guidelines:

•Review the local plumbing codes before you install the unit.

•Connect to the cold water supply.

•The water pressure should be between 20 and 120 psi.

•Install a shut-off valve in the 1/4 inch OD water supply line.

•Connect sufficient tubing to the unit so that tubing may be looped, allowing the unit to be removed for cleaning and servicing (see Figure 39). However, make certain that the tubing is not pinched or damaged during installation.

•U-Line recommends the use of copper tubing for installation.

To connect to water supply:

1.Install the 1/4 inch OD copper water line from the main water source (see Figure 37).

specifications:

•It must be UL listed and have a UL listed, 120 VAC, 3-wire grounded power cord.

•It must have overall maximum outside dimensions of 8-3/4" wide x 5-3/4" deep x 7-3/4" high.

•It must have a minimum flow rate of 15 gallons per hour at 10 feet of lift.

•It must have a sealed sump which does not allow water leakage in the case of a power outage, restricted drain or pump failure.

Water

Connection

Figure 37

Figure 38

•It must have a check valve in the discharge line to prevent waste water return to the pump.

•It must have an overflow protection control which will shut off power to the ice maker in the event of a pump failure.

•It must have an operating temperature range of 50°F to 110°F (10°C to 40°C).

2.Locate the compression fitting and ferrule packed with the unit. Slide the compression fitting and ferrule over the 1/4-inch OD water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the supply line (see Figure 38).

02/2005 15 www.U-LineService.com