™ | CLRCO2075 — Clear Ice Maker/Refrigerator |
|
13/32" |
|
| 0.177" Dia. (#16 Drill) |
|
|
|
|
| 13/32" | |||||
|
|
|
|
|
|
| x | 11/16" Deep |
|
|
|
|
| |
|
|
|
|
|
|
|
|
| 3/8" |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
3/8" |
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
13/16" |
|
|
|
| Door Bottom: | |||||||||
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
| 5/16" Dia. x 1/4" Deep | |||||
|
|
|
|
|
|
|
|
| Chamfer 1/32" x 45° | |||||
|
|
|
|
| Top View |
| Bottom View |
4.Drill hole for upper door hinge (top of panel) (see Figure 16, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
5.Drill hole for lower door hinge (see Figure 16, Bottom View).
5/16" diameter x 1/4" deep
CAUTION
1/8"
13/16"
7/16"
5/16" Dia.
x 1/2" Deep
13/32" | 1/8" |
| 1/8" | ||||
|
|
|
|
|
|
1/32" R
1/8" R
13/16"
3/4"
It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed.
Installation Instructions
Removing Existing Door
1. | Remove the door shelves by first pulling shelves |
| up at a 45° angle then straight out (see Figure 45 |
| on Page 18). |
2. | Remove top hinge screw pin (7/64" hex key or Phillips |
| screwdriver, depending on your unit’s construction). |
| Remove the door by tilting forward and lifting off the |
Back View | Side View |
Figure 16
Route notch in top corner of overlay panel as shown (see Top and Side Views). Top of notch is entire depth of panel, front to back.
bottom hinge pin. |
3. Pull door gasket out of the groove (top edge of door |
only). Start in the middle and pull outward, moving |
toward the edge (see Figure 17). This may take some |
force. |
Width: 13/16"
Depth: 1/8"
Route notch in backside of top corner of overlay panel (see Back and Side Views).
Width: 13/16"
Depth: 1/8"
Height:
Radius of corner notch: 1/8" (see Back View)
3.Drill holes for pivot plate mounts (see Figure 16, Back View).
5/16" diameter x 1/2" deep, from the routed surface
Figure 17 |
New Handle |
Old Handle |
Figure 18 |
CAUTION
Be careful not to drill too deep! Drilling holes too deep may destroy your door panel.
4.Remove the three screws located on the back of the handle (see Figure 18).
02/2005 | 9 |