™ | CLRCO2075 — Clear Ice Maker/Refrigerator |
|
6 Prepare Plumbing
CAUTION
Plumbing installation must observe all state and local codes. All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.
Drain Connection
IMPORTANT
Drain can NOT be located directly below unit. Unit has a solid base that will not allow unit to drain below itself.
The CLRCO2075 can be installed using a Gravity Drain, a
Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor, causing water damage:
Gravity Drain
A Gravity Drain may be used if:
•Drain line has at least a
•Drain line does not create traps or created traps are vented (see Figure 30).
Normal |
Proper Drain |
With Trap |
Poor Drainage, Water Will Back Up |
With Trap and Vent |
Proper Drain |
Figure 30 |
See Figure 31 for a typical Gravity Drain installation.
Gravity Drain |
|
|
|
| Waste |
|
| |
|
| Valve |
|
| Cold |
| Hot | Water |
| Water |
|
Figure 31 | Waste |
|
|
|
If using a Gravity Drain:
1.Attach the
2.Attach the other end of the rigid tube to your
3.Insulate the drain line, if necessary to prevent condensation. Go on to Water Supply Connection.
Factory-Installed Drain Pump
If your drain line will run up to a stand pipe, disposal assembly or spigot assembly or does not otherwise meet the requirements for a Gravity Drain, you may have ordered the CLRCO2075 with a
Stand Pipe |
|
| Waste |
| |
| Valve |
| Cold |
Hot | Water |
Water |
|
Waste |
|
Figure 32 |
|
02/2005 | 13 |