Installation of the CLRCO2075, Relocating the Shelves

CLRCO2075 — Clear Ice Maker/Refrigerator	™
CLRCO2075 — Clear Ice Maker/Refrigerator

9 Install the Unit

Installation of the CLRCO2075

1.Open the water supply valve in the main water source.

2.Make sure the cycle selector switch is in the OFF (middle) position (see Figure 46).

Note: If the cycle selector switch is in the ON or CLN position, water will immediately start flowing into the unit when it is first plugged into the electrical outlet.

3.	Plug in the power cord.
4.	Gently push the unit into position. Be careful not to
	kink the drain or water supply line or entangle the
	electrical cord.

Door Shelves

1.First pull shelf up at a 45° angle, then straight out (see Figure 45).

2.Choose new location and line up on bosses. First push straight in, then down at a 45° angle.

Notch

Boss

Figure 45

5.	Re-check the leveling, from front to back and side to
	side. Make any necessary adjustments. The unit’s top
	surface should be approximately 1/8" below the
	countertop.
6.	Test the drain system by pouring one gallon of water
	into the ice bin. The water should drain freely and there
	should be no leakage.
7.	Remove the tape from the glass shelves and wipe out
	the inside of the unit with a clean, water-dampened
	cloth.

Relocating the Shelves

Both the glass shelves in the refrigerator and the inner door shelves can be moved to accommodate your bottles, cans and containers.

Glass Shelves on Right-Hand Hinge Units

1.Open door fully, grasp shelf firmly, lift front edge slightly, and pull straight out.

2.Choose new location and slide shelf onto the appropriate rib.

Glass Shelves on Left-Hand Hinge Units

Installation Troubleshooting

Q: Problem

Water is leaking under the unit.

A: Solution

A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly. Make sure the fill tube’s connection to the water line is also tight. Check drain line to make sure it has not been disconnected from drain connection on back of the unit or disconnected from the drain.

Q: Problem

The door remains open unless it is pushed closed.

A: Solution

The hinges should be self-closing when the door is open approximately 8". If this is not the case, make sure the closers (at the bottom of the hinge pin) are clean, greased and installed correctly. Also, re-check leveling from front to back of the unit and readjust if necessary. Make sure

1.See Figure 44. Pull shelf out about 6” to clear the wall’s molded protrusion.

2.Tilt right-hand edge of shelf up.

3.Keeping at this angle and hugging the right wall, pull the shelf out.

4.Choose new location and insert over ribs, tilting right-hand edge up. Push in, then lower shelf onto ribs.

1. Pull Out 6"

3. Pull

2. Tilt

Figure 44

that pivot plate is installed correctly.

Q: Problem

The custom overlay door was designed to align with the rest of the cabinet doors, but the unit has crept forward.

A: Solution

First, make sure that the electrical cord and water supply line are not obstructing the installation. If they are not, there is mostly likely not enough room allowed for the drain connection on the rear of the unit. You may need to alter the wall behind the unit to accommodate the drain connection.

www.U-LineService.com

02/2005

CLRCO2075 specifications

The U-Line CLRCO2075 is a high-performance undercounter refrigerator that stands out for its sleek design and versatile functionality. Tailored for both residential and commercial use, this unit exemplifies quality craftsmanship. With a contemporary stainless-steel finish, it seamlessly integrates into any modern kitchen or bar area, elevating the overall aesthetic.

One of the standout features of the CLRCO2075 is its generous storage capacity. It boasts an impressive 5.2 cubic feet of internal space, which can accommodate a wide array of beverages and food items. The refrigerator is designed with adjustable shelves, allowing users to customize the layout to fit their specific storage needs. This flexibility is complemented by a uniquely designed door, which includes a full-length glass panel that not only enhances visibility but also adds a touch of elegance.

Equipped with advanced cooling technologies, the U-Line CLRCO2075 ensures that items are kept at optimal temperatures. The unit employs a dynamic cooling system, which allows it to cool down rapidly and maintain consistent temperatures throughout the interior. This technology ensures that beverages remain refreshingly cold, making it an ideal choice for entertaining guests.

The U-Line CLRCO2075 features user-friendly controls, including a digital touchpad that provides precise temperature settings and easy access to additional functionalities. This includes an integrated alarm system that alerts users if the door is left ajar, which helps to prevent temperature fluctuations and conserve energy.

Another notable characteristic of this refrigerator is its energy efficiency. Designed with eco-friendly principles in mind, the CLRCO2075 meets stringent Energy Star ratings, contributing to reduced energy consumption. This helps not only in lowering electric bills but also in promoting sustainable living practices.

In summary, the U-Line CLRCO2075 is a remarkable addition to any space, combining style, performance, and efficiency. Its ample storage, advanced cooling technologies, user-friendly features, and energy-efficient design make it an excellent choice for those seeking a reliable undercounter refrigerator. Whether for personal or professional use, it meets diverse refrigeration needs while enhancing the overall look of your environment.