Side-By-Side Installation Instructions

™	2015WC/2015WCOL Wine Captain®

4 Prepare Racks and Door Frame

For a complete refreshment center, install your 2015WC or 2015WCOL unit beside a U-Line Refrigerator, Ice Maker or Combo Model (see Figure 11 for typical cut-out). Note that each Side-By-Side Installation will be different.

•Cut-out width for a side-by-side installation is the total of the widths listed under Cut-Out Dimensions in each unit’s Installation Guide.

For example:

Placing a 2015 Wine Captain® next to a 2015 series unit would require a cut-out width of:

15-3/16" + 15-3/16" = 30-3/8"

Placing a 2015 Wine Captain® next to a 2075 series unit would require a cut-out width of:

15-3/16" + 24-3/16" = 39-3/8"

•No trim kit is required. However, 1/4-inch space needs to be maintained between the units to ensure unobstructed door swing.

•Units must operate from separate, properly grounded electrical receptacles placed according to each unit’s Electrical Specifications.

Typical Side-By-Side Cut-Out

The U-Line Wine Captain® is equipped with wood- trimmed wine racks that are coated at the factory with a clear vinyl sealer, which will adequately protect the wood in normal usage. A final finish coat was not applied so that the wood trim could be stained to match décor or overlay frame. The trim on the racks may be coated with a final finish or stained.

2015WCOL Models are designed for, and require installation of, an Overlay Frame.

If none of these treatments are to be included in this installation, go on to 5 Adjust Door.

CAUTION

To prevent permanent damage to the inner liner of the Wine Captain®, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer’s instructions prior to re-installing the wood trim inside the cabinet of the Wine Captain®. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty.

Adding a Final Finish Coat to Wood Trim

34-1/4"	23-1/4"
34-1/4"
to
35-1/8"
	7"
1/4" Space
Between Appliances	1"
Figure 11

1.Remove each wine rack by sliding it out and up. See Figure 12.

2.Remove and save screws securing wood trim to the racks.

3.Lightly scruff sand the wood trim with 280 grit 3M Tri-M-Ite sandpaper.

4.Remove sanding dust with a tack cloth.

Slide Out

and Up

Figure 12

5.Apply a thin coat of Minwax Polycrylic, following container label for directions. Allow to dry 24 hours.

6.Lightly sand, tack and reapply 2 times, if desired.

7.Allow the final coat to dry for 24 hours.

8.Reinstall wood trim to wine racks using screws removed in Step 2.

9.Reinstall wine racks in unit.

10.For 2015WC units, go on to 5 Adjust Door.

02/2005