Smeg LSA6047X instruction manual Installation and hook-up, Water supply connection

Page 21

Installation instructions

2. Installation and hook-up

Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, and screw them to the adjacent units. To facilitate the installation procedure, the intake and drain hoses can be positioned in any direction; make sure that the hoses are not kinked, crushed or pulled too tightly. Make sure to tighten the locking ring-nut once the pipes have been placed in the direction required. A hole at least 8 cm in diameter is required to allow the power supply cable and pipes to pass.

Level the appliance on the floor using its adjustable feet. This operation is essential for ensuring correct operation of the dishwasher.

Installing a hob on top of a free-standing dishwasher is absolutely forbidden. Building-in a dishwasher underneath a ceramic hob is absolutely forbidden.

A dishwasher can be built-in underneath a conventional hob provided there is no break in the kitchen worktop, and the dishwasher and hob are installed and secured correctly, so that no hazards are

generated.

For free-standing models only: if the appliance is not built-in and is therefore accessible on one side, the door hinge area must be covered for safety reasons (injury hazard).

The covering fixtures are available as an accessory from specialist dealers or the After-Sales Service.

Some models are equipped with only one adjustable foot at the rear, which can be adjusted by turning the screw on the lower front part of the appliance.

2.1 Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance.

The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused.



Page 20 Page 22
Image 21
Page 20 Page 22
Contents Guide for Using the Dishwasher and the Washing Programs Contents Front panel Description of the controlsFor AAA 12 place-settings models only see energy label For AAB 12 place-settings models only see energy label For AAB 14 place-settings models only see energy label Washing programs Table for Certification BodiesLighting Programming Selection ProgramStart Program END Program Interruption of a ProgramTo Change a Program Half Load Wash Function on some models only Annulling a ProgramDelay Program on some models only User instructions Removing the Dishes To Save on ENERGY! … and Protect the EnvironmentWater Hardness Table Adjusting the Water Softening SystemCode Phases Lights Description TroubleshootingFor Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upConnecting to the Water Supply Electrical connectionDrain Connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Pull-out version Adjusting the Upper BasketCleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Prolonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data
Top Page Image Contents