Smeg LSA6047X instruction manual Operating instructions, Using the water softening system

Page 23

User instructions

3. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

3.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time. The dishwasher is equipped with an automatic

softening system which uses a specialSALT regenerating salt to reduce the hardness

of the water.

The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.



Image 23
Contents Guide for Using the Dishwasher and the Washing Programs Contents Front panel Description of the controlsFor AAA 12 place-settings models only see energy label For AAB 12 place-settings models only see energy label For AAB 14 place-settings models only see energy label Lighting Washing programsTable for Certification Bodies Start Program ProgrammingSelection Program To Change a Program END ProgramInterruption of a Program Half Load Wash Function on some models only Annulling a ProgramDelay Program on some models only User instructions Removing the Dishes To Save on ENERGY! … and Protect the EnvironmentWater Hardness Table Adjusting the Water Softening SystemCode Phases Lights Description TroubleshootingFor Cleaning Dishwashers Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upDrain Connection Connecting to the Water SupplyElectrical connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Pull-out version Adjusting the Upper BasketCleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Prolonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data