Smeg ST1124 instruction manual END of Cycle, Removing the Dishes

Page 12

User instructions

If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, because it might cause problems in execution of the program.

END OF CYCLE

At the end of the washing cycle the dishwasher gives a short acustic signal and the program indicators nr 4 and 5 start blinking (the word "end" is displayed on the window).

To switch off the dishwasher, open the door and press the ON/OFF button (1).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

27

Image 12

Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Extra Program LightProgramme Number & Symbol Minutes Water Cancelling the Current Program Washing programsTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program Option ButtonAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionConnecting to the Water Supply Electrical connectionDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data 598