Smeg ST1124 instruction manual Aquastop Models

Page 18

Safety instructions

DO NOT UNDER ANY CIRCUMSTANCES TOUCH THE HEATING ELEMENT IMMEDIATELY AFTER THE END OF A WASHING PROGRAM.

OVER TIME, THE DISHWASHER HEATING ELEMENTS MAY CHANGE COLOUR, IN PART OR OVERALL. THIS IS PERFECTLY NORMAL AND DOES NOT IN ANY WAY AFFECT THE OPERATION OF THE APPLIANCE.

DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE.

KNIVES OR OTHER SHARP-ENDED COOKING UTENSILS MUST BE PLACED IN THE CUTLERY BASKET BLADE-DOWN, OR LAID HORIZONTAL IN THE TOP BASKET. TAKE CARE NOT TO CUT YOURSELF AND ENSURE THAT THEY DO NOT PROJECT FROM THE BASKET.

AQUASTOP MODELS

THE AQUASTOP DEVICE PREVENTS FLOODING IN THE EVENT OF A WATER LEAK. WHEN THE AQUASTOP DEVICE IS TRIPPED, CALL IN A QUALIFIED TECHNICIAN TO IDENTIFY AND REPAIR THE FAULT.

IN MODELS EQUIPPED WITH THE AQUSTOP DEVICE, THERE IS A SOLENOID VALVE INSIDE THE WATER INTAKE HOSE. DO NOT CUT THE

HOSE AND DO NOT ALLOW THE SOLENOID VALVE TO DROP INTO WATER. IN THE EVENT OF DAMAGE TO THE WATER INTAKE HOSE, DISCONNECT THE APPLIANCE FROM THE ELECTRICAL POWER SUPPLY AND FROM THE WATER SUPPLY.

IMMEDIATELY AFTER INSTALLING THE DISHWASHER, PERFORM A QUICK TEST OF THE APPLIANCE FOLLOWING THE INSTRUCTIONS BELOW. IF THE DISHWASHER FAILS TO OPERATE CORRECTLY, DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY AND CALL THE NEAREST TECHNICAL SERVICE CENTRE. DO NOT ATTEMPT TO REPAIR THE

APPLIANCE.

THE DISHWASHER MEETS ALL THE REQUIREMENTS SET OUT BY THE REGULATIONS IN FORCE CONCERNING SAFETY AND ELECTRICAL EQUIPMENT. ANY TECHNICAL CHECKS SHOULD BE CONDUCTED EXCLUSIVELY BY A TRAINED AND AUTHORISED TECHNICIAN: REPAIRS

CARRIED OUT BY UNAUTHORISED PERSONS WILL INVALIDATE THE WARRANTY, AS WELL AS POSING A POTENTIAL HAZARD TO THE USER.

The manufacturer declines all responsibility for damage to persons or property resulting from failure to observe the above precautions, from tampering with even a single component of the appliance, or from the use of non original spare parts.



Page 17 Page 19
Image 18
Page 17 Page 19
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Extra Program LightProgramme Number & Symbol Minutes Water Table for Certification Bodies Cancelling the Current ProgramWashing programs Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program Option ButtonAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionConnecting to the Water Supply Electrical connectionDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data 598
Top Page Image Contents