Smeg ST1124 instruction manual Option Button, Delaying the Program

Page 9

User instructions

"3/1" OPTION BUTTON

Pressing this button (8) activates the "3/1" option; the relative light comes on to confirm the selection.

This option is specifically for the use of tablet or powder detergents which already contain salt and rinse aid. If you decide to use a product of this kind, press the button to allow the dishwasher to vary the necessary parameters to ensure the best washing results by making full use of the quantities of detergent, salt and rinse aid these special products contain. At the end of the cycle, the appliance automatically presets for the use of conventional products.

DELAYING THE PROGRAM

The PROGRAM DELAY button (12) can be pressed to delay the start of the program by up to 9 hours. This means that the dishwasher can be operated at the time of day of your choice. Press the button several times in succession and the display will show the delay with which the appliance will start, beginning from 9 hours.

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

Always try to run the dishwasher fully loaded.

Do not wash the dishes in running water.

Use the washing program that is most appropriate for each type of load.

Do not carry out any preliminary rinsing.

If available, connect the dishwasher to a hot water supply up to 60°C.

When possible, disable the drying cycle and leave the door open at the end of the washing cycle: the residual air and heat will dry the dishes perfectly.

TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT

The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent and to save on electricity, observe the following:

separate the more delicate items from dishes that are more resistant to aggressive detergents and high temperatures;

do not pour the detergent directly on the dishes.

24

Image 9
Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsExtra Program Light Setting the Washing Program and Switching onProgramme Number & Symbol Minutes Water Washing programs Cancelling the Current ProgramTable for Certification Bodies Reference standardExtra Programs Selecting Half Load Wash on some models onlyOption Button Delaying the ProgramAdjusting the Water Softening System Electronic Setting models with displayWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upConnecting to the Water Supply Electrical connectionDrain Connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Adjusting the Upper Basket Pull-out versionPush-button version Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data 598