Smeg ST1124 instruction manual Setting the Washing Program and Switching on, Extra Program Light

Page 4

User instructions

EXTRA PROGRAM LIGHT

7Illuminates to indicate that one of the five extra programs (see table) is going to be executed.

8

9

3/1 OPTION BUTTON

Press this button to activate the option for use of 3/1 products.

3/1 OPTION LIGHT

Illuminates to indicate that the function is activated.

HALF LOAD BUTTON (on some models only)

10Press this button to activate the half load wash option. HALF LOAD LIGHT (on some models only)

11One of the two buttons illuminates to indicate that the half load wash option in the top or bottom basket has been selected.

PROGRAM DELAY BUTTON (on some models only)

12Press this button to delay the start of the program by up to 9 hours.

13INFORMATION DISPLAY (on some models only)

SETTING THE WASHING PROGRAM AND SWITCHING ON

To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according to dish type and degree of soiling.

After using the table to identify the most appropriate washing program:

•press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate;

•keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates;

•close the door; after about 2" the program will start. While it is in progress, the relative LIGHT will flash (indicating that the program is being executed).

19

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Guide for Using the Dishwasher and the Washing Programs Contents Description of the controls Upper panelSetting the Washing Program and Switching on Extra Program LightProgramme Number & Symbol Minutes Water Cancelling the Current Program Washing programsTable for Certification Bodies Reference standardSelecting Half Load Wash on some models only Extra ProgramsDelaying the Program Option ButtonElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display END of Cycle Removing the DishesTroubleshooting Fault DescriptionWater intake system malfunction Contents Safety instructions Safety and operating instructionsSafety instructions Aquastop Models Installation and hook-up Water supply connectionElectrical connection Connecting to the Water SupplyDrain Connection Using the water softening system Operating instructionsUsing the rinse aid and detergent dispensers Adjusting the Rinse AID Dispenser Setting Adding the Rinse AIDAdding the Detergent Products General warnings and recommendations User instructions Using the baskets EN 50242 Standard Loads for Certification BodiesLower Basket Loading the Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Pull-out version Adjusting the Upper BasketPush-button version Cleaning and maintenance Cleaning the Water Intake FilterCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsCleaning the Filter Unit Prolonged DisuseBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data 598
Top Page Image Contents