Smeg ST1124 instruction manual Troubleshooting, Fault Description

Page 13

E1

E2

E3

E4

E5

E6

28

User instructions

2. Troubleshooting

The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings:

FAULT

DESCRIPTION

 

 

 

Acquastop failure

 

The anti-flooding system has been activated (for the

 

relevant models only). The system is tripped in case

 

of water leaks. Contact the after-sales service.

Safety level

The system which limits the water level inside the dishwasher has been tripped. Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water heating malfunction

The water is not heated or the heating parameters are not correct. Repeat the washing program; if the problem persists, contact the after-sales service.

Water temperature monitoring malfunction Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water intake malfunction

The appliance does not take in water or does not do so correctly. Check that the water connections are correct, the water intake tap is turned on and the filter is not fouled. If the problem persists, contact the after-sales service.

Water pump-out malfunction

The appliance does not pump out the water or does not do so correctly. Check that the drain hose is not kinked or crushed and that the siphon and filter are not fouled. If the problem persists, contact the after- sales service.

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controlsExtra Program Light Setting the Washing Program and Switching onProgramme Number & Symbol Minutes Water Washing programs Cancelling the Current ProgramTable for Certification Bodies Reference standardExtra Programs Selecting Half Load Wash on some models onlyOption Button Delaying the ProgramElectronic Setting models with display Adjusting the Water Softening SystemWater Hardness Table Switch Setting models without display Removing the Dishes END of CycleFault Description TroubleshootingWater intake system malfunction Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upElectrical connection Connecting to the Water SupplyDrain Connection Operating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the basketsLoading the Lower Basket Lower BasketCutlery Basket Upper Basket Loading the Upper Basket Pull-out version Adjusting the Upper BasketPush-button version Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Avoid the use of acidic or abrasive detergentsProlonged Disuse Cleaning the Filter UnitBefore Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that Technical Data 598
Top Page Image Contents