Smeg CIR60X Instructions for the installer, Positioning Of Hob, Attachment to support structure

Page 4
Instructions for the installer

Instructions for the installer

2. POSITIONING OF HOB

It is the law that all gas appliances are installed by authorised persons. Clearance around the appliance must comply with the requirements of AS5601.

The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).

2.1.1 Attachment to support structure

Create an opening with the dimensions shown in the figure in the top surface of the counter, keeping a minimum distance of 50 mm from the rear border.

This appliance can therefore be mounted against walls higher than the work surface on condition that a certain distance “X” be kept between the appliance and the wall as shown in the figure so as to avoid damage from overheating.

Make sure there is a minimum of 750 mm between the hot plate flames and any shelf that may be installed directly above them.

Accurately position the gasket provided all around the outer edge of the hole in the top surface as shown in the figures below, pressing it down so as to make it adhere properly. For measurements, refer to the figure depending on the hob model to be installed, bearing in mind that in both models the front and rear sides must skim the hole. Secure the hob to the counter with brackets A (supplied). Carefully trim any excess from border B of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket.

6

Image 4
Contents Index Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USETHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLETHE PLATE ON THE CASING MUST NOT BE REMOVED 2. POSITIONING OF HOB Instructions for the installer2.1.1 Attachment to support structure Instructions for the installer 2.2 Clearance above and around domestic appliances REQUIREMENTSbe protected in accordance with Clause 5.12.1.2 to a height C of not 2.3 Room ventilation 2.4 Discharge of combustion products3. GAS CONNECTION 4. ELECTRICAL CONNECTION 5. GAS CONNECTION 5.2 Ventilation of rooms 5.1 Connection to LPG5.3 Discharge of combustion products 6. ADAPTATION TO DIFFERENT TYPES OF GAS 6.1 Removing the hob6.2 Regulation for LPG Burner7. FINAL OPERATIONS 6.3 Regulation for natural gas7.1 Regulation of minimum for natural gas 7.2 Regulation of minimum for LPGThis must be done by a qualified technician BURNERSAuxiliary Semi-rapid8. USING THE HOB Instructions for the userBurner Ø min. and max. in cmAuxiliary Semi-rapid8.4.2 Using the electric elements 9. CLEANING AND MAINTENANCE 9.1 Cleaning9.2 Cleaning of cooking hob components 9.1.1 Regular daily cleaning of the hob9.2.1 Ignition plugs and safety devices 9.3 Preventive maintenance9.2.2 The cover 10.PROBLEMS AND CAUSES PROBLEMCAUSE WHAT TO DOPage 914772609/ B
Related manuals
Manual 25 pages 12.43 Kb