Smeg PS906 manual Fixing to the electric model support structure

Page 11

Instructions for the installer

8.1.2 Fixing to the electric model support structure

Create an opening in the counter top with the dimensions shown in the figure, keeping a minimum distance of 50 mm from the rear edge. The lower part of the casing must be fully accessible after the appliance has been installed.

This appliance can be mounted

against walls higher than the work surface on condition that a distance of “X” be kept between the appliance and the wall as shown in

the figure so as to avoid damage from overheating. Make sure that there is a minimum of 750 mm (Fig.

1)between the hob and any shelf that may be installed directly above it.

This type of appliance also requires milling to a depth of 3

mmon the counter top with the dimensions shown in figure 2

(detail A - The right cross section is recommended for laminated tops where the thickness is less than 3 mm). Before positioning the hob, the supplied adhesive sponge “E” (fig. 2) must be spread out over the entire surface of the milling.

32

Image 11
Contents Contents Instructions for USE Precautions for useInstructions for Disposal OUR Environmental Care Instructions for disposalSafety Instructions Safety instructionsKnow Your Appliance Before InstallationInstructions for the user Gas hob Using the HOBPan diameters Practical tips for using the burnersOrdinary daily cleaning Cleaning and MaintenanceCleaning stainless steel Cleaning the gas componentsFixing to the supporting structure Instructions for the installerInstalling the Appliance Positioning in the counter topInstructions for the installer Fixing to the electric model support structure Instructions for the installer Do not remove this plate for any reason Electrical connectionInstructions for the installer Connection with flexible steel GAS ConnectionConnection to liquid gas Connection with rigid copperExtraction of the products of combustion Room ventilationAdaptation to Different Types of GAS Replacement of nozzles on the cooker hobLiquid GAS G30/G31 28/37 mbar Burner and nozzle characteristics tableLubrication of gas taps Adjusting the minimum for town and natural gasAdjusting the minimum for liquid gas Final Operations for GAS Appliances