Electrical connection | Smeg PS906 specs

Instructions for the installer

Important: other types of installation are possible if supervised by the manufacturer.

Important: for fixing this appliance to the support structure, you are advised not to use mechanical or electrical screwdrivers and to exert moderate pressure by hand on the mounting parts.

Important: for fixing the appliance, use the supplied brackets in all the fixing points.

If this appliance is installed over an oven, the oven must have a cooling fan.

Important (only for Ultra-rapid burners (UR3) (5) with raised pan stands): if the appliance is mounted on a unit, make sure that a separating shelf is installed, as shown in the figure.

If the appliance is instead on an oven installed under the hob, there is no need to install a separating shelf.

If installed over an oven, the oven must have a cooling fan.

8.2Electrical connection

Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing.

Do not remove this plate for any reason.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a fixed connection is being used, fit the power line with an omnipolar circuit breaker with a contact opening gap equal to or greater than 3 mm, in an easily accessible position close to the appliance.