User instructions
SELECTION PROGRAM
The program selection is possible through the relative buttons (2).
By pressing the relative button of desired program (see table) it will lid up the relative pilot light to confirm that the operation did occurred on the DISPLAY (9) will appear a program duration forecasting (“h.mm”).
START PROGRAM
At this point, in order to start the machine, it is only enough to press the START/STOP (5) for some seconds until the writtin “Time to end” start to flash and confirmation “beep” is heard. From this moment the cycle dration on the DISPLAY (8) starts to decrease.
This phase, that updates itself during the cycle, is “indicative” since it is influenced by the washing conditions such as dishwasher type and quantity, entry temperature etc. For this reason it is normal to see the updating during a program (increment and decrease of minutes) specially in the passage from one phase to the other (for example, from washing to rinse).
END PROGRAM
The end of the program is indicated by a short signal acoustic and from the “End” visual notification on DISPLAY (8). By pressing one of the buttons, the “End” visual signal will vanish from the display and the dishwasher is ready to continue a new cycle, the same thing happens when closing or opening the door or by switching
INTERRUPTING A PROGRAM
In order to interrupt a running program it is necessary:
•to press the START/STOP (5) for some seconds until when the writting “Time to end” remains lit on the display (confirmation beep). At this point,it is possible to start the cycle again, otherwise:
12