Smeg DF410BL1 instruction manual General Warnings and Recommendations for Correct Maintenance

Page 29

User instructions

GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:

The filters should be cleaned under running water using a stiff brush.

When removing the filter, take care that there are no food residues on it. If any residues fall into the washing pit they might block hydraulic components, or foul the spray arm nozzles.

It is essential to thoroughly clean the filters according to the above instructions: the dishwasher cannot function if the filters are clogged.

Carefully replace the filters in their seats, to avoid damaging the wash pump.

PROLONGED DISUSE:

Run the soak program twice in succession.

Unplug the power cord from the socket.

Leave the door slightly open, in order to prevent the formation of unpleasant odours inside the washing tank.

Fill the rinse aid dispenser.

Shut off the water supply tap.

BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:

Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes.

Plug the power cord back into the socket.

Reconnect the water intake hose and open the tap again.

TROUBLESHOOTING MINOR PROBLEMS

In some cases it is possible to remedy minor problems by referring to the following instructions:

If the program fails to start, check that:

the dishwasher is connected to the electrical power supply;

there is no power failure;

the water tap is open;

the dishwasher door is properly closed.

If water remains inside the dishwasher, check that:

the drain hose is not kinked;

the drain siphon is not obstructed;

the dishwasher filters are not clogged.

28

Image 29
Contents Guide for Using the Dishwasher and the Washing Programs Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Water supply connection Installation and hook-upDrain Connection Connecting to the Water SupplyIf the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautionsFor Great Britain only User instructionsInformation display Description of the controlsFront panel Only run the soak program with half loads Programming Washing programsLighting Start Program Selection ProgramEND Program Interrupting a ProgramStopping a Program To Change a ProgramUser instructions Removing the Dishes To Save on ENERGY! … and Protect the EnvironmentOperating instructions Using the water softening systemUser instructions Water Hardness Table Using the rinse aid and detergent dispensersAdding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Loading the Lower Basket Using the basketsLower Basket Upper Basket Cutlery BasketLoading the Upper Basket Adjusting the Upper BasketCleaning the Spray Arms Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Filter Unit Cleaning the Spray ARM, Travelling VersionGeneral Warnings and Recommendations for Correct Maintenance If the dishes are not being cleaned properly, check that Troubleshooting Technical Data