Instructions for the Installer
16.FINAL OPERATIONS
After changing the nozzles, put the pan stands, the burner caps and flame diffuser rings back in place.
After adjusting for use of a gas other than the gas used for testing the appliance, replace the gas setting label on the appliance with the label for the new gas. The label is supplied in the bag with the nozzles.
16.1 Adjusting the hob burner minimum for town gas and natural gas
Light the burner and turn it to the minimum setting 
. Remove the gas tap knob and adjust the regulator screw beside the tap rod until an even minimum flame is obtained.
Put the knob back in place and check the stability of the burner flame (the flame must not go out when the knob is turned quickly from the maximum to the minimum setting). Repeat the operation on all the gas taps.
On models equipped with valves, keep the knob pressed down on the minimum setting for a few seconds to keep the flame alight and prime the safety device.
16.2 Adjusting the hob burner minimum for bottled gas
To adjust the minimum level when using bottled gas, the adjuster screw beside the tap rod must be turned fully clockwise.
The diameters of the bypasses for each individual burner are stated in point “15.2 Burner and Nozzle Data Tables”. When the adjustment is complete,
16.3 Positioning and levelling the appliance (only on some models)
After making the electrical and gas connections, level the the appliance on the ground by means of its four adjustable feet. For good cooking results, the appliance must be properly levelled.
Depending on the model you have purchased, the foot height adjustment range may vary from 70 to95
mmand from 110 to 160 mm. These heights refer to the distance between the highest point of thefoot (fixed part) and the lowest point (movable part which rests on the floor).
114