Smeg A11A-5 manual Demo Function

Page 17

Instructions for the user

Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hours after the current time). To set the cooking start/end time, proceed as follows.

-Set the cooking duration time as described in the previous point.

-Within 6/7 seconds after the last time the or keys are pressed, press the key to set the cooking start time. The display

will show the current time with the inside segments indicating the

cooking end time illuminated. Use the and keys to set the cooking start time.

-6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking.

-When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash.

-To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand.

-The image on the right shows an example of programming: the current time is 7.06 and cooking is programmed to start at 8 o'clock and finish at 9.

-At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still.

Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required.

5.2.4 "DEMO" Function

Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating elements while leaving the other functions

unchanged. To activate it, simply press the , and keys for 3/4 seconds. A confirmation beep will inform the user that the function is active. To deactivate it, simply repeat the same procedure.

19

Image 17
Contents Contents Instructions for Safe and Proper USE IntroductionPlate Must not be Removed This rating plate must never be removed Installation of the ApplianceElectrical connection Gas connection Room ventilation Clearance above and around domestic cookers Requirements Instruction for wall fixing Adaptation to Different Types of GAS Replacement of nozzles on the hobArrangement of burners on cooking hob Burner and nozzle characteristics tableFinal Operations Adjustment of minimum for natural gasPositioning and levelling of the appliance Lubrication of gas tapsDescription of Controls Description of SymbolsFront control panel Thermostat KnobCooking HOB Burner Command Knob Function Switch KnobList of Functions Setting the timeElectronic Analogue Clock Minute-minder Programming Demo Function Lighting of the cooking hob burners USE of the Cooking HOBDiameter of containers Practical advice for using the cooking hob burnersOven Light USE of the OvenAvailable Accessories Traditional cooking Function Switch Thermostat Selector Switch from 50 to 250CCooking Hints Hot-air cooking Function Switch Thermostat Switch AT MaximumGrill cooking Make sure that the oven door is closed during cookingFunction Switch Thermostat Switch in Position Function Switch Thermostat Switch from 50 to 250CHot-air grilling DefrostingSpit cooking Cleaning of cooking hob components Cleaning and MaintenanceCleaning stainless steel Do not USE a Steam JET for Cleaning the Inside of the Oven Cleaning of the ovenBurner caps, flame cap crowns and burners Ignition plugs and thermocouplesUsing the self-cleaning liners Self-cleaning linersLooking after the self-cleaning liners Assembling the self-cleaning linersReplacement of light bulb Extraordinary MaintenanceDoor glass Removing the doorOven door seal Preventive maintenance Problems and CausesProblem Cause What to do