Smeg A11A-5 manual Installation of the Appliance, Electrical connection

Page 4

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by authorised persons. Clearance around the cooker must comply with the requirements of AS5601.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

On the power line, install a two-pole cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

If the power cable is replaced, the wire section on the new cable must not be less than 1.5 mm2 (3 x 1.5 cable), keeping in mind that the end to be connected to the hob must have the ground wire (yellow-green) longer by at least 20 mm. Use only the special cables available at our Service Centres.

The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance.

Overall dimensions: location of gas and electrical connection points (all measures in mm).

A 110

B 760

C 150

D 170

6

Image 4

Contents Contents Introduction Instructions for Safe and Proper USEPlate Must not be Removed Electrical connection Installation of the ApplianceThis rating plate must never be removed Gas connection Room ventilation Clearance above and around domestic cookers Requirements Instruction for wall fixing Replacement of nozzles on the hob Adaptation to Different Types of GASBurner and nozzle characteristics table Arrangement of burners on cooking hobAdjustment of minimum for natural gas Final OperationsPositioning and levelling of the appliance Lubrication of gas tapsDescription of Symbols Description of ControlsFront control panel Thermostat KnobFunction Switch Knob Cooking HOB Burner Command KnobElectronic Analogue Clock Setting the timeList of Functions Minute-minder Programming Demo Function USE of the Cooking HOB Lighting of the cooking hob burnersPractical advice for using the cooking hob burners Diameter of containersUSE of the Oven Oven LightAvailable Accessories Cooking Hints Function Switch Thermostat Selector Switch from 50 to 250CTraditional cooking Function Switch Thermostat Switch AT Maximum Hot-air cookingGrill cooking Make sure that the oven door is closed during cookingFunction Switch Thermostat Switch from 50 to 250C Function Switch Thermostat Switch in PositionHot-air grilling DefrostingSpit cooking Cleaning stainless steel Cleaning and MaintenanceCleaning of cooking hob components Cleaning of the oven Do not USE a Steam JET for Cleaning the Inside of the OvenBurner caps, flame cap crowns and burners Ignition plugs and thermocouplesSelf-cleaning liners Using the self-cleaning linersLooking after the self-cleaning liners Assembling the self-cleaning linersExtraordinary Maintenance Replacement of light bulbDoor glass Removing the doorOven door seal Problems and Causes Preventive maintenanceProblem Cause What to do