Smeg A11A-5 Final Operations, Adjustment of minimum for natural gas, Lubrication of gas taps

Page 11

Instructions for the installer

4. FINAL OPERATIONS

After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids.

After adjustment to a different kind of gas from the one for which the cooker has been tested, replace the plate inside the storage compartment with one corresponding to the new kind of gas. This plate can be obtained from your nearest Authorised Assistance Centre.

4.1Adjustment of minimum for natural gas

Light the burner and take it to the minimum. Remove the gas tap knob and turn the adjustment screw inside or at the side of the tap shaft (depending on the model) until there is a regular minimum flame. Replace the knob and check burner flame stability: (rapidly turning the knob from maximum to minimum position, the flame should not go out). Repeat the operation on all the gas taps.

4.2Positioning and levelling of the appliance

Having carried out the electricity and gas hook-up, level the appliance using the four adjustable legs.

4.3 Lubrication of gas taps

With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and re-grease them. This operation must be done by an authorised person.

13

Image 11

Contents Contents Instructions for Safe and Proper USE IntroductionPlate Must not be Removed This rating plate must never be removed Installation of the ApplianceElectrical connection Gas connection Room ventilation Clearance above and around domestic cookers Requirements Instruction for wall fixing Adaptation to Different Types of GAS Replacement of nozzles on the hobArrangement of burners on cooking hob Burner and nozzle characteristics tableLubrication of gas taps Adjustment of minimum for natural gasFinal Operations Positioning and levelling of the applianceThermostat Knob Description of SymbolsDescription of Controls Front control panelCooking HOB Burner Command Knob Function Switch KnobList of Functions Setting the timeElectronic Analogue Clock Minute-minder Programming Demo Function Lighting of the cooking hob burners USE of the Cooking HOBDiameter of containers Practical advice for using the cooking hob burnersOven Light USE of the OvenAvailable Accessories Traditional cooking Function Switch Thermostat Selector Switch from 50 to 250CCooking Hints Make sure that the oven door is closed during cooking Function Switch Thermostat Switch AT MaximumHot-air cooking Grill cookingDefrosting Function Switch Thermostat Switch from 50 to 250CFunction Switch Thermostat Switch in Position Hot-air grillingSpit cooking Cleaning of cooking hob components Cleaning and MaintenanceCleaning stainless steel Ignition plugs and thermocouples Cleaning of the ovenDo not USE a Steam JET for Cleaning the Inside of the Oven Burner caps, flame cap crowns and burnersAssembling the self-cleaning liners Self-cleaning linersUsing the self-cleaning liners Looking after the self-cleaning linersRemoving the door Extraordinary MaintenanceReplacement of light bulb Door glassOven door seal Cause What to do Problems and CausesPreventive maintenance Problem