Smeg A11A-5 manual Adaptation to Different Types of GAS, Replacement of nozzles on the hob

Page 9

Instructions for the installer

3. ADAPTATION TO DIFFERENT TYPES OF GAS

Before performing any cleaning or maintenance work, detach the appliance from the electrical socket.

The hob of the cooker is adjusted for use with either natural gas at a pressure of 1.0kPa (A11X) or LPG (propane) at a pressure of 2.75 kPa (A11XLP). In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flame adjusted on the gas taps. To change the nozzles, proceed as described below.

3.1Replacement of nozzles on the hob

This operation requires no primary air regulation.

1.Extract the grids and remove all the caps and flame-spreader crowns;

2.Unscrew the burner nozzles with a 7 mm socket wrench;

3.Replace the nozzles according to the type of gas to be used and the description in paragraph “3.2 Burner and nozzle characteristics table”.

Replace the burners in the correct position.

11

Image 9

Contents Contents Instructions for Safe and Proper USE IntroductionPlate Must not be Removed Installation of the Appliance Electrical connectionThis rating plate must never be removed Gas connection Room ventilation Clearance above and around domestic cookers Requirements Instruction for wall fixing Adaptation to Different Types of GAS Replacement of nozzles on the hobArrangement of burners on cooking hob Burner and nozzle characteristics tableFinal Operations Adjustment of minimum for natural gasPositioning and levelling of the appliance Lubrication of gas tapsDescription of Controls Description of SymbolsFront control panel Thermostat KnobCooking HOB Burner Command Knob Function Switch KnobSetting the time Electronic Analogue ClockList of Functions Minute-minder Programming Demo Function Lighting of the cooking hob burners USE of the Cooking HOBDiameter of containers Practical advice for using the cooking hob burnersOven Light USE of the OvenAvailable Accessories Function Switch Thermostat Selector Switch from 50 to 250C Cooking HintsTraditional cooking Hot-air cooking Function Switch Thermostat Switch AT MaximumGrill cooking Make sure that the oven door is closed during cookingFunction Switch Thermostat Switch in Position Function Switch Thermostat Switch from 50 to 250CHot-air grilling DefrostingSpit cooking Cleaning and Maintenance Cleaning stainless steelCleaning of cooking hob components Do not USE a Steam JET for Cleaning the Inside of the Oven Cleaning of the ovenBurner caps, flame cap crowns and burners Ignition plugs and thermocouplesUsing the self-cleaning liners Self-cleaning linersLooking after the self-cleaning liners Assembling the self-cleaning linersReplacement of light bulb Extraordinary MaintenanceDoor glass Removing the doorOven door seal Preventive maintenance Problems and CausesProblem Cause What to do