Smeg SE365MF-5 manual Installing the Appliance, Electrical connection

Page 25

Instructions for the Installer

13.INSTALLING THE APPLIANCE

13.1Electrical connection

The nameplate with the technical data, serial number and mark is in a visible position on the oven door frame.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a permanent connection is used, the appliance's power supply line must be fitted with an omnipolar breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

If a socket and plug connection is used, check that they are of the same type. Do not use reducers, adapters or junctions since they may cause overheating or burns.

Operation at 220-240 V~: use a H05RR-Fthree-wire cable (cable of 3 x 1.5 mm2).

The earth wire (yellow-green) must be at least 20 mm longer than the other wires at the end for connection to the appliance.

55

Image 25

Contents Table of Contents Precautions for USE Precautions for UseDisposal Instructions OUR Environment Policy Disposal instructionsSafety Precautions Safety PrecautionsInstructions for the User Before InstallationGET to Know Your Oven Description of Front Panel Controls Thermostat Knob Thermostat Light Electronic Programmer Setting the timeAutomatic cooking Semiautomatic cookingMinute minder End of cooking Adjusting the buzzer volumeStopping the buzzer Deleting the data setPrecautions and General Advice Using the OvenInside light Depending on models Cooling fan system on some models onlyAccessories Available Conventional cooking Cooking AdviceHot air cooking Grilling Delicate cookingHot air grilling Thawing Recommended cooking tables Conventional CookingHOT AIR Cooking Cleaning stainless steel Cleaning and MaintenanceRoutine daily cleaning Food stains or spillsUsing the self-cleaning liners Cleaning the ovenRemoving the self-cleaning liners Cleaning the door glazingExtraordinary Maintenance Instructions for the InstallerChanging the light bulb Removing the gasket Removing the doorElectrical connection Installing the ApplianceCable of 3 x 4 mm2 Positioning the oven Hob-oven connection