Instructions for the user
9.6.2 Setting the cleaning cycle
Use PT2 to select one of the two pyrolysis functions (
and 
) with the oven in ON status.
To start the cleaning (Pyrolysis) cycle, press knob PT1 twice to set its duration (
).
Turn knob PT1 to the right or left to increase or decrease the cycle duration between a minimum of 1h 30m and a maximum of 3h 00m.
(Except for the | function where the cycle duration is fixed at 1h 30m). |
| The message "Pyro" will appear on DSP1 |
| to indicate that the oven is performing the |
| cleaning cycle. |
| The time remaining to the end of the |
| cleaning cycle will be shown on DSP1. |
Two minutes after the cleaning cycle (Pyrolysis) starts an interlock device which prevents opening the door. The
symbol illuminates on DSP2 to indicate that this interlock device has been activated.
At the end of the cleaning cycle the interlock device will remain active until the temperature inside the oven has reached a safety threshold. When the oven has cooled down, collect the residues from automatic cleaning with a damp
To select a cleaning cycle with delayed start, after setting the duration
press PT1 once. The 
symbol and the current time will appear on the display.
Turning PT1 to the right increases the time, allowing the cooking start time required to be set.
A few seconds after the required duration is set, the 
and 
symbols stay on, and the oven will start to wait for the starting time set for the cleaning cycle.
It is not possible to select any functions once the door interlock has been
activated. Wait for the 
symbol to go out.
73