Andrew 5.6-Meter ESA manual Step

Step 7

Step 8

Step 9

Note: If optional motor drive system is included, install motors at this point. Refer to installation instructions provided with motor kits.

Refer to Figure 34. Position hoisting ropes on azimuth motor jack assembly so jack will not roll when hoisted. Attach one rope to motor frame next to gearbox to balance assem- bly. Tie up loose conduit before lifting jack.

Figure 34

Refer to Figure 34. Position hoisting ropes on motor/jack assembly so jack will not roll when hoisted. Attach one rope to large motor frame next to gearbox to balance assem- bly; do not attach rope to small motor. Tie up loose conduit before lifting jack.

Raise 22193/223180 azimuth jackscrew and attach 201287 pivot assembly to 201273 joint assembly with 1 x 2-1/2 in (63 mm) hardware. Note: Mounting position of azimuth pivot jackscrew assembly is dependent upon azimuth range requirements and corre- sponds with mounting position of 201488 outrigger plate or extension assembly.

28 Installation Procedures