I N S TA L L AT I O N I N S T R U C T I O N S
ELECTRICAL R E Q U I R E M E N T S
With the oven positioned directly in front of the cabinet opening, feed the properly rated cord attached to the oven terminal box through the opening in the cabinet platform (where applicable). Then, depending upon local codes, utilize one of the following tech- niques to connect the appliance to the electri- cal power supply.
INSTALLING T H E O V E N
U N PA C K T H E O V E N
Oven is not mounted to the shipping base. Do not remove banding until the oven is at the point of installation.
Cut the plastic straps and remove the two
Remove all oven racks, oven rack guides and broiler pan from inside the oven cavity. For the double oven, be sure to do this for both the upper and lower ovens.
Remove the four bottom corners. Use caution as the oven is not mounted to the shipping base. Keep the bottom foam in place when moving or carting the oven. The bottom foam also protects the
Do not remove the bottom foam until oven has been positioned next to the installation opening.
IMPORTANT NOTE: Before moving the oven, protect any finished flooring with appropriate materials to avoid damage to the floor.
Remove and discard all packing materials, including cardboard and tape on the outside of the oven and inside the oven cavity.
Do not lift the unit by the oven door handle(s). This will damage the oven door and hinges.
17