INSTALLATION
Door Panel Installation
Door
Remove the handle side bracket attached to the front of the door and set aside.
Place the door panel lying face down on a protected sur- face to ensure the front is not scratched or damaged.
Position the plastic template provided flush with the upper edge of the door. Be sure you are following the exact loca- tion for the RH or LH door position. See the following illus- trations.
IMPORTANT NOTE: Remember you are viewing the door panel from the back side in the illustrations. The overall size of the panel shown is the minimum size necessary to cover the door of the unit. The exact measurements of your door panel may vary depending on the particular installa- tion you are following.
CAUTION
Where the reveal on the hinge side of the door panel is less than 1/4", and the panel has a square corner, severe finger pinching or damage to the appliance may occur.
Once you have located the proper position for the hard- ware, mark the holes, remove template, and drill pilot holes for mounting of the hardware. We recommend start- ing the first few holes, positioning the hardware, drilling remaining pilot holes, and securing the mounting brackets with the #8 x 1/2" screws.
Install the door panel by engaging the tabbed bracket to the door first and then sliding the hinge side hardware over the positioning screws. You will have a 1/4" inch adjustment, up and down, side to side, with this hardware.
Once you have the door in place, attach the remaining #8 x 1/2" screws to the hinge side mounting bracket and install decorative caps.
Flush with Top and Side of Panel
| Top |
|
|
|
| Edge of |
|
|
|
Upper | Door | Panel |
|
|
Bracket |
|
| ||
Right |
|
|
| |
Hand |
|
|
| |
| Swing | Upper | Bracket | |
|
| Left |
| |
|
|
| Hand | |
|
|
|
| Swing |
| Door | Panel |
|
| ||||
Drilling |
|
|
| |||||
Template |
| |||||||
|
|
|
|
| ||||
Handle |
|
|
|
|
|
|
|
|
Side | Bracket |
|
|
|
|
|
|
|
Left Hand |
|
|
|
|
|
|
| |
Swing |
|
|
|
| Handle |
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
| Right | Side | Bracket |
|
|
|
|
|
| Hand | ||
|
|
|
|
|
|
| Swing | |
|
|
|
|
|
|
|
| |
| B | eforeCAUTIONd |
|
| ||||
| determ rilling in |
|
|
| ||||
| so sc | ine final set |
|
| ||||
| or | rews |
| p | panels, |
|
| |
|
| styles. | fall w | lacement |
|
| ||
|
|
|
|
| ithin rails |
|
| |
|
| Lower | Bracket |
|
| |||
|
|
|
|
|
|
| ||
Template Positioning
11