Sub-Zero manual Model 315 ICE Maker, Introduction

Page 2

Contents

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-13

Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14-15

Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16-17

Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18

Adjustments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18-19

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . 20-21

Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22

Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23

INTRODUCTION

The Sub-Zero Model 315 is a restaurant-type ice maker designed for home use. It produces the same high quality clear ice that you would expect from Sub-Zero.

This guide is intended as a resource for the installation and operation of the Model 315. Because it contains informa- tion on safety and maintenance, Sub-Zero strongly recom- mends that this manual be read thoroughly and that it be kept where it is readily available.

Before you begin your installation, there are a few things you should take special care to observe.

As you follow these installation instructions, take particu- lar note of the WARNING! and CAUTION! symbols when they appear. This information is important for the safe and efficient installation of this Sub-Zero.

WARNING

alerts you to a hazard that may cause serious injury or death if precautions are not followed.

CAUTION

signals a hazard where minor injury or product dam- age may occur if you do not follow instructions.

In addition, the printed instructions may signal an IMPORTANT NOTE, which highlights information that is especially important for a problem-free installation.

Second, make sure that the actual equipment that was shipped to you matches the design you are expecting to install. If the unit you receive does not match your require- ments, contact your Sub-Zero dealer.

MODEL 315 ICE MAKER

®

2

Image 2
Contents Model ICE Maker Model 315 ICE Maker IntroductionPRE-INSTALLATION Model 315 FeaturesArea Requirements Installations Over a Crawl Space or Base Installation PRE-INSTALLATION SpecificationsPlace ice maker in front of installed location. Adjust Completing the Installation Panel Considerations Models 315 and 315P Door Panel Installation Degree Door Stop Installation Check List Operation Ice Production Cleaning Cleaning the Ice Making System Maintenanceadjustments Adjustments Troubleshooting Condenser completely blocked up, needs cleaning Warranty Sub-Zero Protection PlanService Sub-Zero Freezer Company, Inc