True Manufacturing Company TCGD-50 installation manual Optional Installing Optional Formica KIT

Page 12

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

OPTIONAL (INSTALLING OPTIONAL FORMICA KIT)

FORMICA KIT INSTALLATION:

FORMICA KIT COMPONENTS:

(2)Formica Top End Panels 103/4"w x 33"h (27.3 cm x 83.8 cm).

(2)Bottom End Panels

(1)left side, (1) right side (Formica glued to black plastic panel with 4 key hole slots).

(1)Formica Front Panel

width will vary x 75/8"h (19.4 cm)

NOTE

Please use care when installing the Formica. Formica can chip, crack, or break.

NOTE

Refer to image 1 for placement of Formica panels.

A. Install the front Formica panel.

Be sure bottom end panels are off in order to install front panel. Slide front panel into top and bottom tracks on the front of the cabinet. Make sure panel is even on both left and right end of the cabinet (images 1 & 2).

B. Install the top end Formica panels (one on each side.

Be sure bottom end panels are off in order to install top end Formica panel. Both top end panels are the

STEP A

same size so they each can be used for left or right of the cabinet.

Slide panel up into black plastic tracks on the top side panel of each end of cabinet (images 1 & 3).

Formica top

Formica top

Formica bottom

end panel

end panel

end panel will lock

will slide up

will rest on

through keyholes on

into plastic

screw.

backside of bottom

tracks.

 

end piece.

NOTE

After installing the bottom end pieces the top end panel will stay in place.

C.Install the bottom end Formica panels (one on each side.

(Formica is pre-glued to black plastic panel).

Line up the four keyhole slots in each bottom end piece to the (4) screws on the side of the cabinet. Slip the (4) large keyholes from the bottom end piece over the (4) screws. Then push down to fasten the bottom end piece onto the cabinet (images 1 & 3).

NOTE

The bottom left and right pieces are not the same. The taller part of the bottom end piece goes to the rear of the cabinet as shown in image 3.

1

STEP C

 

 

Four keyholes

 

on backside.

Formica.

STEP B

Tracks to

2hold Formica.

STEP A

Side view of Formica sliding into place for front panel and

3top end panel.

10

www.truemfg.com

10

Image 12
Contents Curved Glass Display Cases DRY Bakery Page Safety Precautions Proper Disposal of the Display Case USE of Extension CordsHard wiring is required on standard Dry Display Cases For models with Optional 12 30.5 cm cordInstallation / Operation Instructions Ownership Required ToolsUncrating StepLocating LevelingTools Required Replacement Parts Electrical InstructionsStartup NON-REFRIGERATED DRY CurvedConductors and Circuits Shelving Installation DRY Bakery Shelf InstallationFor lights to work. If less than Attached caps are plugged intoCastor Installation Tools Required Unit and checkOptional Installing Optional Formica KIT Formica KIT Installation Formica KIT ComponentsRefer to image 1 for placement of Formica panels Cabinet Cleaning Optional Sealing Cabinet to FloorLight Bulb Replacement Shelf Mounted Bulb ReplacementInterior TOP Bulb Replacement ONE Year Parts & Labor Warranty