Audiovox K-9 installation instructions Step #3 Install Console to Floor of Vehicle

Page 7

Step #3 INSTALL CONSOLE TO FLOOR OF VEHICLE

ÞBEFORE DRILLING ANY HOLES VERIFY THAT DRILL BIT WILL NOT ENTER INTO FRAME RAIL(S) OF VEHICLE, ELECTRICAL WIRES, FUEL LINES, BRAKE LINES, HOSES, EXHAUST SYSTEMS OR ANY OTHER ITEMS THAT WILL IMPAIR OPERATION OF VEHICLE. THE BOLTS OF THE FLOOR CONSOLE MUST SECURE TO FLOOR PANEL OF VEHICLE. CLIMB UNDER VEHICLE AND LOOK TO VERIFY THAT HOLES WILL BE IN PROPER LOCATIONS.

ÞSet console on floor of vehicle and mark where holes are to be drilled. Drill small 1/8” pilot holes to verify that drill holes are in proper locations.

ÞAfter verifying that 1/8” pilot holes are in proper locations, use ¼” drill bit to enlarge 1/8” pilot holes.

ÞSet console on floor over holes.

ÞPlace bolts through feet of console and into holes previously drilled.

ÞPlace one large fender washer over each of bolts and attach nuts.

ÞTighten nuts down securely. Have second person inside vehicle hold bolts securely with box-end wrench while person underneath vehicle tightens down nuts.

P/N 8007132

Page 7 of 10

Rev. B

Page 6 Page 8
Image 7
Page 6 Page 8
Contents REV. B BJ Two people are required for installation Step #1 Remove the Face of the Console Step #2 Install brackets and straps Pre-drill 1/8 pilot holes on bottom TV shelf for strap Rev. B Step #3 Install Console to Floor of Vehicle Step #4 Install VCP Into Console Step #5 Install TV Into Console Step #6 Replace the Face of the Console
Top Page Image Contents