AEG D 8 16 40-4 I Electrical connection, Prior to Initial Start-Up, 50 Hz, Setting „0 means Off

Page 12

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup- ply voltage and current values correspond with those of the mains at the installation location.

e.g.:

AC

220 ...

240 V

50 Hz or

 

220 ...

240 V~

50 Hz

 

(i.e. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left.

A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps.

Für eine allfällig notwendige Ausrichtung der Möbeltür, den Spielraum der Langlöcher nut- zen.

Nach Beendigung der Arbeiten das einwandfreie Schließen der Gerätetür überprüfen.

PR168

If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e.g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm).

Attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs.

Prior to Initial Start–Up

Please clean the appliance interior and all accessories prior to initial start- up (see section: “Cleaning and Care”).

Starting up and temperature regulation

Insert the plug into the plug socket. With the refrigerator compartment door open, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment.

Setting „0“ means: Off.

Setting „1“ means: Hightest temperature, (warmest setting).

Setting „6“ (end-stop) means: Lowest temperature, (coldest setting).

However, the exact setting should be chosen keeping in the mind that the temperature inside the refrigerator depends on:

-the quantity of food stored

-how often the door is opened

Die Abdeckung (D) in die Schiene

(B) eindrücken, bis sie einrastet.

Die beiden dem Gerät beiliegenden Winkel (D) zur seitlichen Befestigung des Gerätes am Möbel verwenden. Abedeckung (E) aufklipsen.

B

D

PR167/1

G

H

G

D729

36

13

Image 12
Contents AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG11/03 Regulations, Standards, Guidelines InhaltSicherheit Variable Innentür Feuchteregulierung Variable AblageboxSicherheit Im Alltagsbetrieb Im StörungsfallEntsorgung Transportschutz entfernenEnergy Saving Tips What to do ifAufstellen AufstellortSwitching off the appliance Cleaning and CareIhr Kühlgerät braucht Luft Türanschlag wechselnPreparation of Ice Cubes Freezing CalendarDefrosting Freezing and storing frozen food Belüftungsgitter C und Scharnierabdeckung D auf- steckenFresh food refrigeration Variable Storage BoxBox can be inserted under any door shelf compartment Interior Accessories Storage ShelvesVariable Inner Door Moisture regulatorStarting up and temperature regulation Setting „0 means OffElectrical connection Prior to Initial Start-UpElektrischer Anschluß Vor InbetriebnahmeInbetriebnahme und Temperaturregelung Stellung „0 bedeutet ausInnenausstattung AbstellflächenVariable Innentür WichtigRichtig lagern FeuchteregulierungVariable Ablagebox Der Luft in den Obst- und Gemüse- schalen einEinfrieren und Tiefkühllagern Ren kann Nachstehend einige praktische RatschlägeHousing dimensions Eiswürfel bereitenGefrierkalender Instructions for total built-inAbtauen Gerät abschaltenInstallation Installation LocationReinigung und Pflege WarnungRemove transport safeguard DisposalTips zur Energie-Einsparung Was tun, wennDaily Operation Case of malfunctionSafety Lampe auswechselnBestimmungen, Normen, Richtlinien Contents