Whirlpool FGP315B Lighting standing pilots, To light range pilots, To light oven burner pilot

Lighting standing pilots

(mode& FGP21OV,FGP3WB and FGPNOB)

To light range pilots:

1.Make wre all controls are tumed off.

2.Remove the surface burner grates from the cookhp. Remove the cookop. (See “Removingthe woklop” on page 18.)

3.To light, hold a lit match over the pilot light located between the front and back burners. The pilot flame should be %fo % in (.6-l cm) high.

4.If the pilot flame needs adJustment, turn the pilot adjustment screw behind the Oven Temperature Control, under the control panel.

5.Replace the cooktop and the grates before using the surface burners.

To light oven burner pilot:

1.Make sure the Oven Temperature CoMrol k turned off.

2.Pull broiler drawer open. Broiler door will till down when opened.

3.Remove broiler pen, grid, and broiler carriage. (SW “Removingthe broiler carriage” an page 21.)

4.Hold a lit match over the oven burner pilot located at the rear of the burner.

5.After the oven burner pilot is burning steadily, check burner lighting by turning the Oven Temperature Control to a tempemture above 140°F (60%). The burner will take 50-W Seconds to light.

6.Replace the burner carriage, broiler pan, and grid.

7.Close broiler drawer all the way.

Pllot

adJumtment ! ‘1

8CCreW

4

11