USING YOUR RANGE
THE ELECTRONIC TIME-OF-DAY (TOD) CLOCK/TIMER
Electronic display
|
| Increase |
|
| |
|
| pad |
Clock pad |
| (p. 10, 11, |
| 14, 19) | |
(pp. 10, 14) |
| |
|
|
Oven
timer pad (p. 11, 12)
CLOCK
TIMER
TIMER
Decrease pad
(pp. 10, 11, 14, 19)
Display/clock
•When you first plug in the range, “PF” will appear on the display. If “PF” appears again on the display, your electricity was off for a while.
•When you are not using the oven, the display shows the time of day.
•When showing the time of day, the display will either show the hour and minutes or will be blank.
•When you are using the timer, the display will show seconds for time less than 1 minute, minutes for time less than 1 hour, and hours and minutes for time over 1 hour. The timer indicator light will be lit when in the timer mode.
SETTING THE CLOCK
PRESS | YOU SEE |
1.Press CLOCK. The colon flashes during
clock programming.
2. Set the time. | PRESS | YOU SEE |
Press the “up” (▲) or “down” (▼) pad(s) until |
|
|
the correct time shows on the display. |
|
|
NOTE: Press a pad briefly to change time by a |
|
|
small amount. Press and hold a pad to change |
|
|
time by 10 minute increments. |
|
|
3. Press CLOCK again to start the clock. The | PRESS | YOU SEE |
colon stops flashing when the clock is active. |
|
|
10