Whirlpool Slide-In Electric Ranges Electrical Requirements, Type of Gas, Natural gas

Page 6

Electrical Requirements

Gas Supply Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

This range is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

The wiring diagram is located on the underside of the storage drawer or below the warming drawer in a clear plastic bag.

NOTE: The metal chassis of the range must be grounded in order for the control panel to work. If the metal chassis of the range is not grounded, no keypads will operate. Check with a qualified electrician if you are in doubt as to whether the metal chassis of the range is grounded.

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CGA B149 - latest edition.

IMPORTANT: Leak testing of the range must be conducted according to the manufacturers instructions.

Type of Gas

Natural gas:

This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas.

This range is factory set for use with Natural gas. See “Gas Conversions” section. The model/serial rating plate located behind the storage drawer on the right-hand side oven door frame has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. See “Gas Conversions” section.

6

Image 6
Contents Installation Instructions 30 76.2 CM Freestanding and SLIDE-IN GAS RangesRange Safety Table of ContentsWhat to do if YOU Smell GAS Installation Requirements Tools and PartsLocation Requirements Slide-in Range Product Dimensions Freestanding RangeInstallation Clearances Freestanding and Slide-in RangesNatural gas Electrical RequirementsType of Gas LP gas conversionGas Supply Line Gas Supply Pressure TestingCountertop Preparation Gas Pressure RegulatorInstall Anti-Tip Bracket Unpack RangeVerify Anti-Tip Bracket Location Install Rear VentLevel Range Make Gas ConnectionCheck Operation Typical flexible connectionComplete Connection Check Operation of Cooktop Burners Standard Surface Burners Adjust Flame HeightAdjust Oven Bake Burner Flame if needed Three Flame BurnerReplace Oven Racks & Storage or Warming Drawer Complete InstallationAdjust Oven Broil Burner Flame if needed Check Operation of Oven Broil BurnerTo Convert Gas Pressure Regulator GAS ConversionsLP Gas Conversion Gas pressure regulatorTo Convert Standard Surface Burners To Convert Three Flame Burner on some modelsNatural Gas Conversion To Convert Oven Bake BurnerTo Convert Oven Broil Burner Stamped number Plate External gas orifice spud Internal gas orifice spud Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteExigences D’INSTALLATION Exigences demplacementOutillage et pièces Dimensions du produit Cuisinière autoportante Cuisinière coulissanteDégagements de séparation à respecter Spécifications électriques Cuisinière autoportante et coulissanteSpécifications de l’alimentation en gaz Type de gazCanalisation de gaz Instructions D’INSTALLATION Préparation du plan de travailDéballage de la cuisinière Installation de la bride antibasculement Raccordement à la canalisation de gaz Installation du raccord du conduit ’évacuation à l’arrièreVérification de lemplacement de la bride Antibasculement Mise à niveau de la cuisinièreRaccordement typique par raccord flexible Compléter le raccordementRéglage de la taille des flammes Contrôle du fonctionnementBrûleur à triple réglage Contrôle du fonctionnement du brûleur du fourAchever l’installation Contrôle du fonctionnement du brûleur du grilSil est nécessaire de régler la taille des flammes Conversion du détendeur Conversions Pour Changement DE GAZConversion pour lalimentation au propane Si la cuisinière ne fonctionne pas, contrôler ce qui suitConversion des brûleurs standard de la table de cuisson DétendeurConversion du brûleur du four Conversion du brûleur du grilConversion pour lalimentation au gaz Naturel Chiffre gravé Conversion du brûleur du four Holes in bracket Trous dans la bride 9761413B

Slide-In Electric Ranges specifications

Whirlpool slide-in electric ranges are designed to bring convenience, style, and efficiency to the modern kitchen. These innovative appliances stand out not just for their aesthetics but also for their advanced features and technology that cater to a range of cooking needs.

One of the main characteristics of Whirlpool slide-in electric ranges is their seamless design. Unlike traditional freestanding models, slide-in ranges have a built-in appearance, fitting snugly between cabinets for a sophisticated look. This design eliminates the gap between the range and the countertop, preventing spills and crumbs from accumulating. Additionally, the front-control design places the controls at the front of the unit, allowing easy access and eliminating the need to reach over hot pots and pans.

Whirlpool electric ranges are equipped with powerful and precise cooking technologies. Many models feature advanced induction cooking options that provide rapid heating and consistent temperature control. Induction cooking utilizes electromagnetic energy to directly heat pots and pans, making it faster and more energy-efficient compared to traditional electric coils or radiant burners. For those who prefer traditional cooking, the ranges often come with smooth-top radiant elements, which provide a modern surface that is easy to clean.

In terms of oven features, Whirlpool slide-in electric ranges include convection cooking options, which circulate hot air throughout the oven for even baking and roasting. This technology ensures that food cooks consistently and eliminates the need for manual rotation. Additionally, many models offer self-cleaning options, making maintenance easier and freeing up time for users.

Another noteworthy feature is the FlexHeat Dual Radiant Element, offering flexibility in cooking. This element is equipped with both 6-inch and 9-inch zones, allowing cooks to match the size of their cookware with the burner size, optimizing energy use.

Connectivity is also a significant aspect of modern Whirlpool electric ranges. Many of their models are Wi-Fi-enabled, allowing users to control their ovens remotely using a smartphone. This means preheating the oven, adjusting cooking temperatures, and even setting timers can all be accomplished from anywhere in the home.

Whirlpool slide-in electric ranges combine functionality with stylish design, bringing energy-efficient cooking and advanced technology to kitchens. With features such as versatile cooking surfaces, advanced oven technology, and smart capabilities, these ranges are ideal for both seasoned chefs and home cooks alike. Whether you’re baking, broiling, or simmering, a Whirlpool slide-in electric range is designed to enhance culinary experiences while complementing any kitchen décor.