Whirlpool W10258095A installation instructions Wire connection Power Supply Cord

■Position cord/conduit plate as shown in the following illustration.

B

A

A. Small opening

B. Large opening

■Replace cord/conduit plate and insert screws.

B

A

A. Small opening

B. Large opening

■Assemble a UL listed conduit connector in the opening.

Electrical Connection Options

If your home has:	And you will be	Go to Section:
	connecting to:
4-wire receptacle	A UL listed,	4-wire connection:
(NEMA type 14-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord
4-wire direct	A fused	4-wire connection:
	disconnect or	Direct wire
5"	circuit breaker
	box
(12.7 cm)
3-wire receptacle	A UL listed,	3-wire connection:
(NEMA type 10-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord
3-wire direct	A fused	3-wire connection:
1"	disconnect or	Direct wire
(2.5 cm)	circuit breaker
	box
3"
(7.6 cm)

A

C

B

A. Removable retaining nut - small opening

B. Conduit connector

C. Large opening

■Feed the flexible conduit through the strain relief, allowing enough slack to easily attach wiring to the terminal block.

■Tighten strain relief screw against the flexible conduit.

5.Replace back panel and screws on rear of range.

6.Complete installation following instructions for your type of electrical connection:

4-wire(recommended)

3-wire(if 4-wire is not available)

4-wire connection: Power Supply Cord

Use this method for:

■New branch-circuit installations (1996 NEC)

■Mobile homes

■Recreational vehicles

■In an area where local codes prohibit grounding through the neutral

1.Part of metal ground strap must be cut out and removed.

A

B

C

A. Metal ground strap

B.Discard

C.Ground-link screw

2.Use Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground link under the screw.

7