Whirlpool SF385PEE warranty Adjust by, This Number, To Cook Degrees, Fahrenheit

Page 17

USING YOUR RANGE

ADJUSTING THE OVEN TEMPERATURE CONTROL

Although your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven.

If you are not satisfied with the baking/roasting results, you can change the offset temperature by following the steps below.

NOTE: DO NOT measure the oven temperature with a thermometer. Opening the oven door will lower the oven temperature and give you an incorrect reading. Also, the thermometer temperature reading will change as your oven cycles.

1.Press and hold the bake pad for 5 seconds.

The display will show the current offset tempera- ture, for example “0,” if you have not already adjusted the temperature.

PRESS

YOU SEE

BAKE

(factory setting of “0”)

2.Set the new offset temperature.

Press s to raise the temperature or t to lower the temperature in 10°F amounts. You can set the temperature change to as low as -30°F or as high as +30°F. A minus (-) sign will appear before the number when decreasing the temperature setting. The minus sign shows the oven will be cooler by the displayed amount. There is no sign in front of the number when increasing the temperature setting.

PRESS

YOU SEE

TEMP

(example when making oven 10°F cooler)

3.Enter the adjustment.

NOTE: The oven control will stay adjusted even after a power failure.

PRESS

YOU SEE

START

ENTER

5 SEC

(time of day)

How to determine the amount of adjustment needed

The chart at the right tells you how much to adjust the offset temperature to get the cooking results you want. You can figure out cooking results by the amount of browning, moistness, and rising times for baked foods.

 

ADJUST BY

 

THIS NUMBER

TO COOK

OF DEGREES

FOOD ...

(FAHRENHEIT)

 

 

A little more

+10

Moderately more

+20

Much more

+30

A little less

-10

Moderately less

-20

Much less

-30

17

Image 17
Contents Part no Rev. C Cubic Foot OvenLook for these tips Thank you for buying a Whirlpool applianceOn next Range SafetyImportant Safety Instructions For units with ventilating hood For self-cleaning rangesControl panel Automatic oven light switch p Parts and FeaturesControl Panel Storage drawerUsing the Surface Burners Using Your RangeUsing the control knobs Burner heat settingsTo protect your range Using the right cookware makes a big differenceHome canning information Positioning Racks and Pans Rack placement for specific foodsGeneral guidelines Food Rack PositionFor Best AIR Circulation Where to place pansWhen YOU have Place Display/clock Using the control lockElectronic Oven Control Example for 10 minutes Example forTo cancel the minute timer STARTING/CANCELING a FunctionExample for bake at 375F BAKING/ROASTINGRoasting meats and poultry Example for set temperature of 350F Save energy and save money This Number Adjust byTo Cook Degrees FahrenheitBroiling Example shows broil at 400F Broiling TipsExample shows broil at 325F Rack Minutes Meat Position Side Broiling guideApproximate Time ANTI-TIP Bracket Oven VentRemoving the storage drawer Storage DrawerReplacing the storage drawer Lower slide rail inside drawer Opening Upper drawer guidesBefore YOU Start Before you start the Self-Cleaning cycle, make sure youExample shows 41⁄2-hour cleaning time Setting the ControlsHOW the Cycle Works Self-cleaning tipsCaring for Your Range Cleaning ChartPart HOW to Clean Cleaning the contoured well areas Cleaning the cooktopContoured well area For the proper flow of gas and ignition Cleaning the surface burnersPorcelain Removing the Oven Door To clean the burnersInsert door Oven door Range Hinge hangerFrom the range To removeTo replace To replace the oven light Oven LightProblem Cause TroubleshootingRange does not Work OVEN/BROILER BurnerDisplay Messages When SELF-CLEANING Your OvenCooking Results Our consultants provide assistance with Requesting Assistance or ServiceTopic IndexWarranty Length of Warranty Whirlpool will PAY for Full ONE-YEARService company From Date of Purchase