Whirlpool RF377PXG, RF378PXG manual Removing the Oven Door, To remove, To replace

Page 38

CARING FOR YOUR RANGE

REMOVING THE OVEN DOOR

For normal use of your range, you do not need to	Door removal	Door stop clip
remove the door. However, if you find it necessary	Door removal	Door stop clip
to remove the door, follow the instructions in this	pin hole
section.
NOTE: The oven door is heavy.
Before removing the door:
1. Use a putty knife or screwdriver and insert it at
the bottom corner of the door stop clip.		Range
		Range

2. Pry door stop clip free and remove from front frame hinge slot. Take care not to scratch porcelain.

3.Repeat procedure for other door stop clip.

Hinge	Front frame
hanger	hinge slot

To remove:

1.Open the oven door. Insert door removal pins, included with your range, into both hinge hangers. Do not remove the pins while the door

is removed from the range.

2.Carefully close the door until it rests against the door removal pins.

3.Grasp the door on the sides with your fingers on the front of the door

and your thumbs on the inside surface.

4.Pull door straight up, then toward you. Hinge hangers will slide out of front frame hinge slot.

To replace:

NOTE: The door removal pins you inserted must still be in both hinges.

1.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.

38

Image 38

Contents Cubic Foot Oven 8053400800 253 Range Safety On nextImportant Safety Instructions For self-cleaning ranges For units with ventilating hoodRemovable storage drawer p Parts and FeaturesControl Panel Area you are setting Model RF378PXG Oven vent p Cleantop ceramic glass cooktopSurface heating Indicator light Left front Left rear Right rear Right front Control knobUsing the control knobs Using Your RangeUsing the Surface Cooking Areas Setting Recommended USETo protect your range Home canning informationOptional canning kit Surface PanCookware tips Cookware with a non-stick finish has heatingHot surface indicator lights Using the ceramic glass cooktopWhen YOU have Place Rack placement for specific foodsWhere to place pans Positioning racks and pansUsing Aluminum Foil Bakeware ChoicesDisplay/clock Indicator lights Using the control lockElectronic Oven Control Press Clock Setting the ClockUsing the Electronic Minute Timer Example forDisplay counts down STARTING/CANCELING a FunctionTo clear the display, turn off the minute timer Time of dayBAKING/ROASTING Rear of rackExample for set temperature of 325F Roasting meats and poultryFactory setting On next Saving energyTo Cook Degrees Adjust byThis Number FahrenheitBroiling Front of rack Rear of rackStart the oven Broil indicator light will light upPress Custom Broil Rack Minutes Meat Position Side Broiling guidelinesApproximate Time Example shows 10-minute baking/roasting time Cook time indicator light will light upExample shows bake at 375F Press Cook Time Display counts down cook time To delay start and stop automaticallyChoose the bake setting Start time/delay indicator light will light up Example shows 2 o’clock start timeCeramic glass cooktop model When the start time is reachedOven Vent Coil element modelRemoving the storage drawer ANTI-TIP BracketStorage Drawer Replacing the storage drawerTips Before you start the Self-Cleaning cycle, make sure youBefore YOU Start Example shows 41⁄2-hour Setting the ControlsCleaning time To stop the self-cleaning cycle at any time HOW the Cycle WorksCleaning Chart Caring for Your RangeCleaning Chart Cleaning the Ceramic Glass Cooktop Model RF378PXG Removing ReplacingCoil Elements and Reflector Bowls Model RF377PXG LIFT-UP Cooktop Model RF377PXG To replace Removing the Oven DoorTo remove Oven Light To replace the oven lightProblem Cause TroubleshootingWhen SELF-CLEANING Your Oven Range does not WorkProblem Solution Cooking ResultsRequesting Assistance or Service Our consultants provide assistance withIndex TopicFull FIVE-YEAR Length of Warranty Whirlpool will PAY for Full ONE-YEARWarranty Whirlpool will not PAY for