Receiving & Unpacking
1.Inspect the carton and note any damage, regardless if it appears minor. If the carton is damaged, note on the consignee copy of the freight invoice “exterior carton damage - concealed damage possible.”
2.Cut the plastic banding strap and remove the exterior carton sleeve, internal fillers and plastic bag around the dispenser. Carefully inspect for damage.
Note: IMI Cornelius is not responsible for damaged freight. If damage is found, you must save all packaging material and contact the freight carrier. Failure to contact the carrier within 48 hours of receipt may void your claim.
3.Confirm receipt of the installation kit #720202300 packaged with the dispenser. If any item is missing, contact our customer service department at
Kit Contents: |
|
Qty | Description |
4 | 3/8” barb |
4 | 3/8” swivel nut |
5 | 3/8”x3/8” elbow barb |
6 | 3/8” nylon washer |
10 | #170 clamps |
10 ft. | 3/8” braided tubing |
4 ft. | 1/2” I.D. clear tubing |
1 | 1/2”x1/2” 90o elbow |
4 | Generic |
2 | Flavor strip kits |
1 | Installation template |
4.Remove the four 9/16” (15 mm) retaining bolts from the underside of the shipping pallet by carefully tilting the dispenser from side to side.
5.With the assistance of another person, lift the dispenser from under the base and place it on the counter.
The dispenser is extremely heavy when operational. Make certain the counter can support a minimum of 300 lbs directly below the dispenser.
Installation
Typically the dispenser is placed directly on the counter and a food grade silicone sealant applied around the base. However, an optional leg kit is available. The following instructions assume the optional leg kit will not be used.
Depending on the type of counter, it may be
necessary to provide access through
the counter at the rear of the dispenser
for the drain, power, water and concentrate connections. Refer to the
template enclosed in the installation kit.
Connect Water Supply:
Water pipe connections and fixtures directly connected to a potable water supply shall be sized, installed, and maintained according to federal, state, and local laws.
Wilshire recommends that a ½” O.D. copper supply line with a
a.Assemble the 3/8” braided water supply line furnished in the Installation Kit by attaching the straight barb on one end and the elbow barb on the other. Secure with clamps provided.
4