Cornelius SID650A/80-BC, SID650W/80-BC manual Harvest Time Adjustment

Page 35

HARVEST TIME ADJUSTMENT

WARNING: Disconnect electrical power to the unit before servicing the timer in the electrical box.

1.Disconnect power to ice maker.

2.Remove upper front panel and electrical control box cover.

3.Place the “Stop/Run”switch in the “Stop”position.

4.Using Figure 9 as a guide, set the timer cam tabs as follows, starting with cam wheel No.1 (all cam tab positions are in relation to No.1 left cam tab).

NOTE: Timer cam wheels can be manually rotated only in the normal direction of rotation-downward as viewed from the front of the unit.

A.“Manually”adjust the cam tabs by using each “click”as the cam tab is rotated, as equivalent to .75 seconds.

B.Set up cam wheel No.1 with the left and right cam tabs back-to-back as shown in Figure 9A.

C.Adjust the cam tabs on wheels No. 2 through No. 5 in sequence as shown on the chart. Rotate the cam wheels manually downward to set each wheel.

D.After the cam tabs are manually set, reconnect power to the ice maker.

E.Rotate the cam wheels slightly to activate the timer motor (No. 1 tell-tale down).

F.Using a stop watch, time the cam switch tell-tales. Adjust the cam tabs as necessary for the required cycle times.

MANUAL FILLING

In the event that the ice maker is not functioning, the hopper may be manually filled with ice.

1.Open the hinged service door.

2.Place the “Stop/Run”switch in the “Stop”position.

WARNING: Electrical power is on to the agitator motor and the gate solenoid. Avoid contact with these components.

3.Remove the ice drop and storage hopper covers.

4.Fill hopper with ice and replace covers. Unit is now ready for dispensing.

CAUTION: Do not use crushed or flaked ice. Use of bagged ice, which has frozen into large chunks, can void warranty. The agitator is not designed to be an ice crusher. Use of large

chunks of ice which “jam up” inside the hopper will cause failure of the agitator motor and damage the hopper. If bagged ice is used, it must be carefully and completely broken into small, cube-size pieces before filling into the storage hopper. Do not allow foreign material to enter the ice storage hopper.

91704

32

Page 34 Page 36
Image 35
Page 34 Page 36
Contents Spiral Icemaker Dispenser Table of Contents Table of Contents cont’d Description General InformationUnpacking Instructions Installation InstructionsInstallation Instructions Electrical Wiring Installation Instructions Installations Dimensions Mounting Template Model SID650-80 START-UP Beverage SystemBeverage System Schematic B Models Beverage System Schematic BC Models Operating Instructions Harvest Cycle Time Cam Switch ActionWiring Schematic Wiring Diagram Refrigeration Schematic Cleaning Instructions MaintenanceDispenser Section Cold Plate For Units with Beverage System91704 Troubleshooting Guide 91704 91704 Is ICE Production ICE Maker Problem YES RUN RUN/STOP Stop Hopper YES Present AT No ICE on Evaporator Harvest YES 10%? Adjust ICE Thickness Probe only After ALL OTH LOW ICE Production 91704 Dispenser Problem YES Does 91704 BIN Thermostat MAINTENANCE/ADJUSTMENT ProceduresCLEANING/REPLACE the Filter Harvest Time Adjustment Distributed By Commercial Refrigeration Service, Inc Description Part Numbers Parts ListAir Cooled Water Cooled Refrigeration Components 80 BC Parts List CONT’DWarranty Remcor Incorporated Regency Drive Glendale Heights, IL 708
Top Page Image Contents