TAPE OPERATIONS
En
* Open the control panel with PANEL OPEN/CLOSE if needed.
Playback
Use only type I (normal) tapes.
1Press TAPE and insert the tape in either deck. Press zPUSH EJECT to open the cassette holder, and insert with the exposed side down and playback side facing out from the unit. Push the cassette holder to close.
2Press d.
"l"(forward) or "j"(reverse) on the display indicates the playback side.
14
To stop playback
Press s.
To pause playback (DECK 2 only)
Press a. Press again to resume.
To fast forward or rewind
Press for g.
To change the playback side(DECK 1 only) Press din play or pause mode.
To select a deck (DECK 1 or DECK 2)
Press TAPE in stop mode when tapes are loaded in both decks. The deck number ("TP1"or "TP2") is displayed.
To reset the tape counter
Press sCLEAR in stop mode, and the tape counter on the display is reset to "0000".
Opening and closing the cassette holder will also reset the tape counter.
To play continuously (DECK 1 to DECK 2)
Load tapes in both decks and start playback on DECK 1. Then, as soon as playback on DECK 1 finishes, playback on DECK 2 will start without interruption.
To play back type II (High position) tapes
Turn MULTI JOG until "SOFT" is displayed while playing a type II tape. Then, the unit provides the optimum playback sound for type II tapes.
Notes on cassettes
•Use of
•Take up any slack in the tape with a pencil or similar tool before use. Slack tape may jam in the mechanism.
•"SOFT" sound for type II tapes described above is canceled when the graphic equalizer is turned on, the cassette holder is opened, the function is changed, or the unit is turned off.
Basic recording
Use only type I (normal) tapes. DECK 2 is the recording deck. Only one side of the tape can be recorded at a time.
1Insert the recording tape in DECK 2.
Press zPUSH EJECT to open the cassette holder, and insert with the exposed side down and the side to be recorded on facing out from the unit.
Wind up the tape to the desired point if needed.
2Prepare the source.
To record CD(s), select the CD function and load disc(s). To record a radio broadcast, tune in to the desired station. To record a tape, select the tape function and insert the source tape in DECK 1.
To record from connected external equipment, select the VIDEO (AUX/TV) function and prepare the equipment.