Aiwa AV-D30 manual Manual Tuning, Direct Tuning, Press the UPA or Downy button to select a station

Page 12

MANUAL TUNING

1 Press the TUNER button repeatedly to select the desired band.

~

The display changes to frequency indications after indicating band and video source (V1, V2 or V3) for two seconds.

When the TUNER button is pressed while the power is off, the power is turned on directly.

2 Press the UPA or DOWNY button to select a station.

Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for two seconds. During FM stereo reception, [{(m)]) is displayed.

To search for a station quickly (Auto Search)

Keep the UPA or DOWNT button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops.

To stop the Auto Search manually, press the UPA or DOWNY button,

The Auto Search mqy not stop at stations with ‘“veryweak signals.

When an FM stereo broadcast contains noise

Press the MONO TUNER button on the remote control so that “MONO appears on the display.

Noise is reduced, although reception is monaural.

To restore stereo reception, press the button so that “MONO?’ disappears.

DIRECT TUNING

f?====%

I

DOWNY, UPA

When you know the frequency of the desired station, you can tune in directly to the station.

1 Press the TUNER button to select a band.

2 Press the TUNER button and hold it down until .....“flashes on the display (DirectTuning Mode).

3 Press the appropriate numbered buttons,to tune in to the desired station.

Example:

To tune in to 106.50 MHz, press 1, 0, 6, 5 and O buttons. To tune in to 95.20 MHz, press 9, 5, 2 and Q buttons.

To cancel the Direct tuning mode

Press the UPA or DOWNY button.

When using the remote control

Carry out steps 1 and 2 above, and press the numbered buttons on the remote control to tune in to the desired station.

When entering a frequency out of tuning range, the value flashes for two seconds and then goes off. Check the frequency and repeat step 3 correctly.

When entering” a frequenc~ not covered by the tuning interval, the value is automatically rounded up or down to the closest one covered by it.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Hold down the TUNER button and press the POWER button immediately. Note that the unit is set to the Direct Tuning mode if the TUNER button is pressed and held down for about half a second.

To reset the interval, repeat this procedure.

Image 12
Contents Call toll free I-800-BUY-AIIWA Precautions InstallationElectric Power AC power cordTable of Contents Connecting Equipment ConnectionsConnecting Speakers @ Connecting + to +, -to terminalsSpeaker terminals Speaker impedanceConnecting the Supplied Antennas @ Connecting AN Outdoor AntennaPositioning the Speakers Abouttheremote Control Press one of the function buttons TUNEFI, PhcinoVideo 3 or the Tape Monitor button To select the front speaker systemCustom Audio Adjustment Volume ControlSound Adjustment During Recording Super T-BASS SystemElectronic Graphic Equalizer DSP SurroundStart the selected program source Adjust the sound Select the function to be adjustedSelection of AUDIO/VIDEO Source Select the program sourceRecording AN Audio Source TI Play a DVD Recorded in Dolby Digital SurroundStart playing the DVD recorded in Dolby Digital Surround Select the program source to be recordedManual Tuning Direct TuningPress the UPA or Downy button to select a station Presetting Stations Preset Number TuningTo clear a preset station Repeat steps 1To Select a Dolby PRO Logic Mode Selecting Dolby PRO LogicAdjusting Speaker Level Balance Adjust the sound level of the center and surrcwncl speakersDolby PRO Logic Normal or Wide mode Dolby PRO Logic Phantom modeSetting the Clock Setting the Sleep TimerPress the SET button Care and Maintenance FM tuner sectionAM tuner section Amplifier SectionTroubleshooting Guide GeneralGeneral Tuner SectionVideo Volume Parts IndexAUX Balance Clock Dolby Surround Down SET Sleep Tape Monitor Bass Tuner BandPrecauciones InstalacionEneruia electrica Indice Antena exteriorMantenimiento Dafios que reauieren reparationConexiones ~ Conexion DE EquiposConexion DE LOS Altavoces @ Conexion de Ios terminates + a +, y aSurround Speakers Ubicacion DE LOS Altavoces Conexion DE LAS Antenas Suministradas @Conexion DE UNA Antena Exterior Antes DE LA Operacion Sobre EL Controlador RemotoSeleccion del sistema de altavoces delanterc~s Control DEL Volumen GustoSistema Super T-BASS Ajuste DEL Sonido Durante LA GrabacionPara cancelar el modo seleccionado Ecualizador Grafico ElectronicSonido Perimetrico DEL Procesador Desenal Digital Para seleccionar con el controlador remotoSeleccion DE UNA Fuente DE Seleccione la fuente de programasPara ajustar el nivel del sonido de la fuente conectada Seleccione la funcion que desee ajustarGrabacion DE UNA Fuente DE Audio Seleccione la fuente de programas que desee grabarSintonia Manual Sintonia DirectaMemorization DE Emisoras Sintonia DE Emisoras POR W Numero DE MemorizationRepita Ios pasos 1 y Para borrar utli~ emisora memorizactaSeleccion .DE Dolby PRO Logic Para Seleccionar UN Modo Dolby PRO LogicModo recomendado Ajuste DEL Equilibria DEL ’WEL Entre Altavoces Modo Dolby PRO Logic Normal O WideModo Dolby PRO Logic Phantom Modo 3 Stereo Normal O WidePuesta EN Hora DEL Reloj Presione el boton SETPara hater que se visualice la hors actual Para cambiar al rnodo de 24 horasCuidados Y Mantenimiento Especificaciones Seccion de! sintonizador de FMSeccion del sintonizador de AM Seccion del amplificadorGuia Para LA Solucion DE Problemas Seccion generalSeccion General Seccion DEL SintonizadorIndice DE LAS Partes SET Sleep Tape Monitor Bass Tuner Band UP aElectricity Releve du proprietaireCordon d’alimentation secteur Table DES Matieres Antenne exterieureEntretien Reparations exiqeant I’intervention d’un professionnelRaccordements Raccordement DE Tout ’EQUIPEMENT11111 Avant de raccorder Ie cordon secteurRaccordement DES Enceintes @ Positionnement DES Enceintes Raccordement DES Antennes Fournies @Raccordement D’UN Antenne Exterieure @ Caisson de gravePF?OPOS DE LA Telecommande Avant DE CoivimencerSelection de la paire d’enceintes avant Reglage DE Volume Reglage Personnel DU SONSysteme Super T-BASS Reglage DU SON Pendant ’ENREGISTREMENTEgaliseur Graphique Electronique Processeur D’AMBIANCEAppuyez sur une des touches DSP DANCE, Live Selectionnez la so,urce de programme Demarrez la source de programme sekctionneeSelectionnez la fonction dent Ie niveau doit &re ajuste Appuyez de fagon repetee sur la touche UPA ouEnregistrement D’UNE Source AudioAccord Manuel Si vousConnaissezla frequencede la station souhaitee, vousQuand une emission FM stereo est parasitee Quand vous utilisez la Itelecommande Priereglage DES StationsAccord DES Stations Prereglees Refaites Ies operations 1 etPour Selectionner UN Mode Dolby PRO Logic Mode conseilleSelection DU Dolby PRO Logic Select pour arr~ter Ie signal Reglage DE LA Balance DUREGLAGEDEL’HORLOGE Reglage DE LA Minuterie ’ARRETPour afficher I’heure actuelle Soin ET Entretien Section TunerSection Tuner AM Section AmplificateurEN CAS DE Panne GeneralitiesSection Tuner Aucun sonVideci Video Volume AUX Balance Clock Dolby Surround DownySET SLEEF’ Tape Monitor Bass Tunertunerband UPA

AV-D30 specifications

The Aiwa AV-D30 is a compact yet powerful mini stereo system that combines high-quality audio performance with user-friendly features. Designed for music enthusiasts who desire convenience without sacrificing sound quality, the AV-D30 offers a range of capabilities that make it an excellent choice for both casual listening and more critical audio experiences.

One of the standout features of the Aiwa AV-D30 is its integrated CD player, which supports various formats, allowing users to enjoy their favorite CDs with clarity and depth. The system is also equipped with a built-in cassette deck, catering to those who still cherish their analog recordings. This combination of digital and analog playback options highlights Aiwa's commitment to versatility and nostalgia, making it appealing to a wide audience.

The AV-D30 includes a radio tuner with AM and FM capabilities, enabling users to explore a diverse range of radio stations. The presence of digital tuning ensures that station selection is effortless, while preset options allow listeners to save their favorite frequencies for quick access. With its RDS (Radio Data System) feature, the system provides additional information such as station names and song titles, enhancing the overall listening experience.

In terms of sound performance, the Aiwa AV-D30 boasts a robust amplifier that delivers rich and powerful audio output. The dual speakers are designed to provide balanced sound across a variety of musical genres, ensuring that both highs and lows are faithfully reproduced. Users also have access to various sound enhancement features, including equalizer settings, allowing them to tailor their listening experience according to personal preferences.

Connectivity is another strong point of the AV-D30, featuring auxiliary inputs that enable users to connect external devices such as smartphones, tablets, or laptops. This makes it easy to stream music directly from personal devices, broadening the system's functionality. Additionally, the presence of headphone and line-out ports adds to the versatility, accommodating different listening scenarios.

Compact in design, the Aiwa AV-D30 fits seamlessly into any living space, while its straightforward controls make operation hassle-free. With a combination of aesthetic appeal and technological features, this mini stereo system is ideal for music lovers seeking a reliable and enjoyable audio solution. Overall, the Aiwa AV-D30 represents a harmonious blend of modern technology and classic design, embodying the spirit of quality sound in a compact package.