Aiwa AV-D30 manual Setting the Clock, Setting the Sleep Timer, Press the SET button

Page 16

SETTING THE CLOCK

1,3,5

1,,----,!.

When the AC cord is connected for the first time, the clock on

the display flashes.

Set the time as follows while the power is off.

1 Press the SET button.

The hour flashes.

2 Press the DOWNY or UPA button to designate the hour.

3 Press the SET button to set the hour.

The hour stops flashing and the minute starts flashing.

4 Press the DOWNY or UPA button to designate the minute.

5 Press the SET button to set the minute.

The minute stops flashing on the display and the clock starts from 00 second.

To correct the current time

Press the POWER button to turn the unit off. Press the SET button and carry out steps 1 to 5 above.

To display the current time

Press the CLOCK button on the remote control. The clock is displayed for 4 seconds. ,

To switch to the 24-hour standard

Press the POWER button while pressing the UPA or DOWNY button while the current time is displayed.

Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes while the power is off

This is caused by a power interruption. The current time needs

to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

SETTING THE SLEEP TIMER

The receiver can be automatically turned off at a specified time.

Use the remote control.

1 Press the SLEEP button.

2 Press the UP> or DOWN< button within

four seconds to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off

Press the SLEEP button once. The remaining time is displayed

for four seconds.

To cancel the sleep timer

“

Press the SLEEP button twice so that “SLEEP” on the display

disappears.

I 5 ENGLISH

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Call toll free I-800-BUY-AIIWA Precautions InstallationElectric Power AC power cordTable of Contents Connecting Equipment ConnectionsConnecting Speakers @ Connecting + to +, -to terminalsSpeaker terminals Speaker impedanceConnecting AN Outdoor Antenna Connecting the Supplied Antennas @Positioning the Speakers Abouttheremote Control Press one of the function buttons TUNEFI, PhcinoVideo 3 or the Tape Monitor button To select the front speaker systemCustom Audio Adjustment Volume ControlSound Adjustment During Recording Super T-BASS SystemElectronic Graphic Equalizer DSP SurroundStart the selected program source Adjust the sound Select the function to be adjustedSelection of AUDIO/VIDEO Source Select the program sourceRecording AN Audio Source TI Play a DVD Recorded in Dolby Digital SurroundStart playing the DVD recorded in Dolby Digital Surround Select the program source to be recordedDirect Tuning Manual TuningPress the UPA or Downy button to select a station Presetting Stations Preset Number TuningTo clear a preset station Repeat steps 1To Select a Dolby PRO Logic Mode Selecting Dolby PRO LogicAdjusting Speaker Level Balance Adjust the sound level of the center and surrcwncl speakersDolby PRO Logic Normal or Wide mode Dolby PRO Logic Phantom modeSetting the Sleep Timer Setting the ClockPress the SET button Care and Maintenance FM tuner sectionAM tuner section Amplifier SectionTroubleshooting Guide GeneralGeneral Tuner SectionVideo Volume Parts IndexAUX Balance Clock Dolby Surround Down SET Sleep Tape Monitor Bass Tuner BandInstalacion PrecaucionesEneruia electrica Indice Antena exteriorMantenimiento Dafios que reauieren reparationConexiones ~ Conexion DE EquiposConexion de Ios terminates + a +, y a Conexion DE LOS Altavoces @Surround Speakers Conexion DE LAS Antenas Suministradas @ Ubicacion DE LOS AltavocesConexion DE UNA Antena Exterior Sobre EL Controlador Remoto Antes DE LA OperacionSeleccion del sistema de altavoces delanterc~s Control DEL Volumen GustoSistema Super T-BASS Ajuste DEL Sonido Durante LA GrabacionPara cancelar el modo seleccionado Ecualizador Grafico ElectronicSonido Perimetrico DEL Procesador Desenal Digital Para seleccionar con el controlador remotoSeleccion DE UNA Fuente DE Seleccione la fuente de programasPara ajustar el nivel del sonido de la fuente conectada Seleccione la funcion que desee ajustarGrabacion DE UNA Fuente DE Audio Seleccione la fuente de programas que desee grabarSintonia Manual Sintonia DirectaMemorization DE Emisoras Sintonia DE Emisoras POR W Numero DE MemorizationRepita Ios pasos 1 y Para borrar utli~ emisora memorizactaPara Seleccionar UN Modo Dolby PRO Logic Seleccion .DE Dolby PRO LogicModo recomendado Ajuste DEL Equilibria DEL ’WEL Entre Altavoces Modo Dolby PRO Logic Normal O WideModo Dolby PRO Logic Phantom Modo 3 Stereo Normal O WidePuesta EN Hora DEL Reloj Presione el boton SETPara hater que se visualice la hors actual Para cambiar al rnodo de 24 horasCuidados Y Mantenimiento Especificaciones Seccion de! sintonizador de FMSeccion del sintonizador de AM Seccion del amplificadorGuia Para LA Solucion DE Problemas Seccion generalSeccion General Seccion DEL SintonizadorIndice DE LAS Partes SET Sleep Tape Monitor Bass Tuner Band UP aReleve du proprietaire ElectricityCordon d’alimentation secteur Table DES Matieres Antenne exterieureEntretien Reparations exiqeant I’intervention d’un professionnelRaccordements Raccordement DE Tout ’EQUIPEMENT11111 Avant de raccorder Ie cordon secteurRaccordement DES Enceintes @ Positionnement DES Enceintes Raccordement DES Antennes Fournies @Raccordement D’UN Antenne Exterieure @ Caisson de graveAvant DE Coivimencer PF?OPOS DE LA TelecommandeSelection de la paire d’enceintes avant Reglage DE Volume Reglage Personnel DU SONSysteme Super T-BASS Reglage DU SON Pendant ’ENREGISTREMENTProcesseur D’AMBIANCE Egaliseur Graphique ElectroniqueAppuyez sur une des touches DSP DANCE, Live Selectionnez la so,urce de programme Demarrez la source de programme sekctionneeSelectionnez la fonction dent Ie niveau doit &re ajuste Appuyez de fagon repetee sur la touche UPA ouEnregistrement D’UNE Source AudioSi vousConnaissezla frequencede la station souhaitee, vous Accord ManuelQuand une emission FM stereo est parasitee Quand vous utilisez la Itelecommande Priereglage DES StationsAccord DES Stations Prereglees Refaites Ies operations 1 etMode conseille Pour Selectionner UN Mode Dolby PRO LogicSelection DU Dolby PRO Logic Select pour arr~ter Ie signal Reglage DE LA Balance DUReglage DE LA Minuterie ’ARRET REGLAGEDEL’HORLOGEPour afficher I’heure actuelle Soin ET Entretien Section TunerSection Tuner AM Section AmplificateurEN CAS DE Panne GeneralitiesSection Tuner Aucun sonVideci Video Volume AUX Balance Clock Dolby Surround DownySET SLEEF’ Tape Monitor Bass Tunertunerband UPA

AV-D30 specifications

The Aiwa AV-D30 is a compact yet powerful mini stereo system that combines high-quality audio performance with user-friendly features. Designed for music enthusiasts who desire convenience without sacrificing sound quality, the AV-D30 offers a range of capabilities that make it an excellent choice for both casual listening and more critical audio experiences.

One of the standout features of the Aiwa AV-D30 is its integrated CD player, which supports various formats, allowing users to enjoy their favorite CDs with clarity and depth. The system is also equipped with a built-in cassette deck, catering to those who still cherish their analog recordings. This combination of digital and analog playback options highlights Aiwa's commitment to versatility and nostalgia, making it appealing to a wide audience.

The AV-D30 includes a radio tuner with AM and FM capabilities, enabling users to explore a diverse range of radio stations. The presence of digital tuning ensures that station selection is effortless, while preset options allow listeners to save their favorite frequencies for quick access. With its RDS (Radio Data System) feature, the system provides additional information such as station names and song titles, enhancing the overall listening experience.

In terms of sound performance, the Aiwa AV-D30 boasts a robust amplifier that delivers rich and powerful audio output. The dual speakers are designed to provide balanced sound across a variety of musical genres, ensuring that both highs and lows are faithfully reproduced. Users also have access to various sound enhancement features, including equalizer settings, allowing them to tailor their listening experience according to personal preferences.

Connectivity is another strong point of the AV-D30, featuring auxiliary inputs that enable users to connect external devices such as smartphones, tablets, or laptops. This makes it easy to stream music directly from personal devices, broadening the system's functionality. Additionally, the presence of headphone and line-out ports adds to the versatility, accommodating different listening scenarios.

Compact in design, the Aiwa AV-D30 fits seamlessly into any living space, while its straightforward controls make operation hassle-free. With a combination of aesthetic appeal and technological features, this mini stereo system is ideal for music lovers seeking a reliable and enjoyable audio solution. Overall, the Aiwa AV-D30 represents a harmonious blend of modern technology and classic design, embodying the spirit of quality sound in a compact package.
Top Page Image Contents