ATTO Technology 463-248-202 manual Mounting PagePac Plus AmpliCenter, Tools Required

Mounting PagePac Plus AmpliCenter

NOTE: Figure 3-3 illustrates a wall mounted configuration. Figure 3-4illustrates a rack mounted arrangement.

The AmpliCenter must be securely wall mounted or installed in a standard 19" EIA cabinet or free-standing equipment rack (Wall mount wood screws not provided).

Tools Required

The following tools are required for the installation of the system hardware and cabling.

■Phillips screwdriver (for 10-32 screws)

■Standard blade screwdriver (small, for terminal block connections and level adjustments)

■Wire strippers (24 AWG -12 AWG)

■Telephone test set (optional, for troubleshooting)

■Tone out circuit tester (optional, for troubleshooting)

■Portable 70V speaker (use cabling pulled for ceiling speakers) (optional, for troubleshooting)

■Volt-Ohm Meter (optional, for troubleshooting)

■4 wood screws, if mounting on wall

SIDE VIEW FRONT VIEW

AMPLICENTER

6 FOOT	MUSIC INPUT
POWER CABLE

PAGE INTO

AMPLIFIER

Figure 3-3. Wall Mounted Hardware

3-6Installing the Hardware